PowerJump LMD-021 User manual
PowerJump LMD-021 Jump Starter
Thank you for choosing the PowerJump LMD-021 Jump
Starter! Always follow basic safety precautions when using
electrical appliances. Read all instructions carefully.
Please keep this instruction manual for easy reference.
USER MANUAL
B| ACCESSORIES:
ACCESSORIES:
USB Charging Cable Heavy-duty PowerJump
Jump Starter Cable
A| PRODUCT LAYOUT:
Micro 12V 1A Input
LED illumination
USB 5V 2A Output
Button A
Indicator light
Jump Start Socket
Actual product colour may vary from picture
11
D| LED ILLUMINATION / FLASH LIGHT
Press and hold Button A for 3 seconds to start the LED illumination /
Flashlight. The 4 modes (Normal Flashlight; Flash; SOS and OFF) appear in
sequence when Button A is pressed lightly.
C| INDICATOR LIGHTS
Press Button A to check the power level of the PowerJump Jump Starter.
When charging, indicator lights will flash one by one. The number of solid
indicator lights indicates the power level of the
PowerJump Jump Starter. Indicator lights are solid when charging is
paused or complete
Indicator lights 1 Flashing 1 Solid 2 Solid 3 Solid 4 Solid
Power Level 0% 25% 50% 75% 100%
22
E| JUMP STARTING A 12V VEHICLEE| JUMP STARTING A 12V VEHICLE
1. Make sure that the PowerJump Jump Starter’s power level is at
least 75%.
2. Make sure all vehicle lights are switched off (interior and exterior),
including hazard/emergency lights.
3. Make sure Fan / Air Conditioning / Heater are switched off.
4. Plug the Cord of the PowerJump cable into the Jump Start socket.
5. Connect the RED battery clamp of the PowerJump cable to the vehicle's
POSITIVE (+) battery terminal and connect the BLACK battery clamp of
PowerJump cable to the vehicle's NEGATIVE (-) battery terminal.
6. Wait 60 seconds.
7. Start the vehicle.
9. Remove the PowerJump cable from the Jump Start socket.
10. Leave the vehicle’s engine running
1. Make sure that the PowerJump Jump Starter’s power level is at
least 75%.
2. Make sure all vehicle lights are switched off (interior and exterior),
including hazard/emergency lights.
3. Make sure Fan / Air Conditioning / Heater are switched off.
4. Plug the Cord of the PowerJump cable into the Jump Start socket.
5. Connect the RED battery clamp of the PowerJump cable to the vehicle's
POSITIVE (+) battery terminal and connect the BLACK battery clamp of
PowerJump cable to the vehicle's NEGATIVE (-) battery terminal.
6. Wait 60 seconds.
7. Start the vehicle.
9. Remove the PowerJump cable from the Jump Start socket.
10. Leave the vehicle’s engine running
Never allow clamps to touch each other or to contact the same piece of metal to prevent sparking.
PowerJump should be re-charged after each use. No more than 3 jump
starts per single charge.
8. Once the vehicle starts, WITHIN 30 SECONDS disconnect the BLACK
battery clamp from the vehicle’s NEGATIVE (-) battery terminal, then
disconnect the RED battery clamp from the vehicle’s POSITIVE (+) battery
terminal.
33
1. Connect the USB charging cable to the USB 5V 2A Output.
2. Choose the correct charging connector for the mobile electronic device
and plug it into the mobile electronic device’s charging port.
3. Press Button A to charge the mobile electronic device.
1.Plug the charging cable into the car charger (supplied) or into a wall
charger.
2. Plug the Mini USB connector into the Micro 5V 1A Input on the
PowerJump Jump Starter.
G| CHARGING THE POWERJUMP JUMP
STARTER
F| CHARGING MOBILE DEVICES
Hold the PowerJump Jump Starter
firmly in one hand.
With the other hand, squeeze the
blue plug and remove it from the
Jump Start Socket.
F| REMOVING THE POWERJUMP
JUMP STARTER CABLE FROM
THE JUMP START SOCKET
H| TECHNICAL SPECIFICATIONS:
Size:
Capacity:
Output:
Input:
Current:
139*79*18mm
600mAh
USB 5V / 2A
5V/1A
180A ~350A
44
I| FAQ:
Q: How do you turn off the PowerJump Jump Starter?
A: The PowerJump Jump Starter will power off automatically when there is
no load present or charging is complete.
Q: On a single charge, how many times can the PowerJump Jump Starter
be used to start a vehicle?
A: Approximately 3 times on a full charge.
Q. How long will PowerJump Jump Starter keep its charge if left unused?
A: Approximately 6 months. However, it is recommended to charge the
PowerJump Jump Starter every 3 months.
J| WARNING:
1. PowerJump Jump Starter LMD-021 is only for use on 12V Petrol vehicles
(up to 3 litres).
2. When Jump Starting a vehicle, ensure that the blue plug is inserted
securely in the Jump Start Socket.
3. Always ensure that the battery clamps are connected correctly.
4. Once the vehicle starts, always remove the battery clamps WITHIN 30
SECONDS.
55
WARRANTY INFORMATION:
1. Lamador (Pty) Ltd offers a limited warranty for this product against any
defects in material and workmanship for a period of 12 months from the
date of purchase by the end user/consumer.
2. The warranty is only valid upon presentation of the original receipt
(from dealer/retailer) by the original purchaser with the product to be
repaired or replaced
3. The warranty is void if the serial number, date of purchase or Rating
Label has been removed
4. The warranty does not cover damage or product failure resulting from
normal wear and tear, physical abuse, improper installation, misuse,
modification or repairs by unauthorized third parties
5. We do not assume responsibility for any loss or damage incurred during
shipment or as a result of a force majeure.
6. Lamador (Pty) Ltd is not liable for any incidental or consequential
damages arising from the use or misuse of this product
7. AII warranty claims are limited to repair or replacement of the defective
product and at the sole discretion of Lamador (Pty) Ltd.
8. If the PowerJump Jump Starter is repaired or replaced, the product will
be covered for the remaining time of the original warranty period. Repair
or replacement may involve the use of reconditioned units which are
equivalent in function. The replaced part or product becomes the property
of Lamado r (Pty) Ltd.
9. For a full set of Terms and Conditions,
please visit www.PowerJump.co.za
66
Always take care when using the appliance.
This appliance is not intended for use by young or infirm persons
without supervision.
Do not use as a toy.
Do not allow the PowerJump Jump Starter to become wet.
Do not immerse the PowerJump Jump Starter in water.
Do not operate the PowerJump Jump Starter in explosive
atmospheres, such as in the presence of flammable liquids, gases or
dust.
Do not modify or disassemble the PowerJump Jump Starter.
Do not expose the appliance to heat.
Do not store in locations where the temperature may exceed 70 °C. •
Charge only at ambient temperatures between 0 °C and 60 °C. Under
extreme conditions, battery leakage may occur. Carefully wipe the
liquid off using a cloth and avoid skin contact when you notice liquid
on the batteries. In case of skin or eye contact, rinse immediately
with clean water and seek medical attention.
TOXIC & HARMFUL SUBSTANCES:
Amount of toxic & harmful substances in the PowerJump Jump Starter
Indicates all homogeous materials’ hazardous substances content are below the MCV limit
specified in the Standard 2002/95/EC (RoHs).
The PowerJump Jump Starter LMD-021
is distributed by Lamador (Pty) Ltd.
www.PowerJump.co.za
Made in China
For a full set of Terms and Conditions,
please visit www.PowerJump.co.za
Please register your warranty at www.PowerJump.co.za/warranty
77
Table of contents
