K2 Yeti Clamp 2.0 User manual

k2-systems.com
CONNECTING STRENGTH
K2 Yeti Clamp 2.0
QUICK GUIDE

2
Part Number Description
4000050-B Yeti Clamp 2.0, Set
Components
Tools overview
13 mm dep socket
TTorque 11.8 ft-lbs
10-50 ft-lb
(6 - 35 Nm)
The K2 Yeti Clamp 2.0 must be installed in an array. It cannot be installed on a single module that is not connected to the
array by a mid clamp.
Important note
Frame Compatibility:
Flange Thickness = 1.6 - 2.5 mm
Flange Width = 15 - 40 mm
15 - 40 mm
0.59 - 1.57 in
1.6 - 2.5mm

3
Assembly
2
1
!With the Paper Strap unrolled, slide the K2 Yeti Clamp 2.0 into the rail channel with the screw facing out.
Slide the K2 Yeti Clamp 2.0 onto the rail leaving enough room to place the module.
!The K2 Yeti Clamp 2.0 comes pre-assembled and ready to install. Unfold the Paper Strap located at the
bottom of the K2 Yeti Clamp 2.0.
The Paper Strap acts as an aid to facilitate installation.

4
4
3
!Use a standard ratchet or drill with a 13mm deep box socket and drive in the socket head cap screw and
tighten to 12 ft-lbs.
NOTE: While tightening the K2 Yeti Clamp 2.0 with the socket pull the Paper Strap towards you.
Do not use an impact drill.
!Position the module flush to the end of the rail. Pull the Paper Strap toward
you so the K2 Yeti Clamp 2.0 slips over the module frame

5
6
5
!Install end cap to create a flush, clean look!
!
Be sure that the module is properly fastened with the K2 Yeti Clamp 2.0.
The inside edge of the module frame flange must be fully engaged with the K2 Yeti Clamp 2.0 as shown in the
image.
Quick Guide K2 Yeti Clamp 2.0 US V1 | 0623 · Subject to change · Product illustrations are exemplary and may differ from the original. original