Pearl CH-1030B User manual

CH-1030CCH-1030B
Instruction Manual
Congratulations on your purchase!
For optimum performance, please read this Instruction Manual before playing.
CH-1030B/CH-1030C
PEARL CYMBAL HOLDER
Boom Tilter
StopLock
Boom Tilter
StopLock
Wing Bolt
Wing Nut Wing Nut
Wing Bolt
WingLoc
StopLock
StopLock
Reversible Seat Cup
Gyro-Lock Tilter
Reversible Cymbal Washers
Knurled Post for Cowbells, etc.

Fig. 6
WingLoc
Pearl’s patented WingLoc's quick release design makes
attaching and removing cymbals quick and easy.
Reversible Seat Cup
The Seat Cup is reversible and can be set to Float, to
allow cymbals to move freely, when set in the position
shown in (Fig.5-A) or it can Lock, to prevents rattle in
recording situations, when set in the position shown in
(Fig.5-B).
Reversible Cymbal Washer
The CH-1030B/CH-1030C Cymbal Holder is equipped with
Reversible Cymbal Washers with a Felt side and Foam
side. With the Foam side against the cymbal, a bright,
clear sound with long sustain is achieved. The Felt side
gives a warmer and softer sound. Mix and match the top
and bottom Reversible Cymbal Washers to find the sound
you like best (Fig.6).
Float
Fig. 5-A
Lock
Fig. 5-B
To remove the WingLoc, pull the
wings apart and lift the WingLoc
straight up (Fig.1).
To attach, keep the
wings open and place
the WingLoc and the
Upper Cymbal Washer
over the Cymbal Post as
shown (Fig.2).
To adjust, snap either
one of the wings upward
as shown in Fig.3 and
rotate the WingLoc until
the desired tightness /
looseness of the cymbal
is achieved. Snap the
other wing upward
(Fig.4) to lock the
WingLoc in place.
Fig. 1
Fig. 2
Fig. 3 Fig. 4
Upper
Cymbal Washer
Cymbal Post
NOTE
・Do not force the wings closed. If you feel resistance, rotate
the WingLoc slightly to align the threads and try closing the
wings again.
・Do not tighten the WingLoc when both wings are in the
locked position to prevent wear to the threads.
・Keep the WingLoc in the locked position when transporting
to avoid breakage or loss.
https://www.pearldrum.com
Products and specifications are subject to change without notice.
Printed in China
-Nov 2020-
Foam
Felt
Combination Example
Test the stability of the stand before use. If needed, try
one or combinations of the suggestions below until
the stand is sufficiently stable.
• Adjust the length of the boom arm.
• Change the direction of the boom arm.
• Shift the weight of the load.
Before use, check to ensure all Wing Bolts, Wing Nuts,
Bolts, and Screws on the Cymbal Holders are tight
and secure.
CAUTION