Kellfri 28-TH6P User manual

28-TH6P
BLANKET RACK
CAREFULLY READ THE OPERATING INSTRUCTIONS BEFORE USING THE PRODUCT!
OPERATING INSTRUCTIONS TRANSLATED FROM THE ORIGINAL

2
INTRODUCTION
Thank you for choosing a product from Kellfri AB. By following the general safety information
and the instruction manual and by using common sense, you will have a great and safety use
of your Kellfri product for many years. Kellfri designs and delivers eective, aordable ma-
chinery and components for forest, agriculture, construction and gardening in Sweden, other
Nordic countries and Europe.
PRODUCT INFORMATION
Practical, black powder coated blanket rack with room for 6 thick and heavy blanket. Sturdy
frame with 2.5 cm diameter pipes. Installation only requires 68,5 cn wide wall space.
The arms are rotatable which allows the air to circulate around each blankets. The arms are
foldable in the side taking taking a minimal space when not in use.
At the bottom there is an extra arch which can be use to hang shin guards, covers or
caparisons.
INTENDED USE
The machine is intended for hanging items, separating items.
FOR YOUR SAFETY
Before using the product, please read the safety information and instruction manual and
understand its contents for your own and others’ safety. Always keep the safety information
and instruction manual easily accessible to the user of the product.
Remember that it may be good for your own and others’safety to read the safety information
every now and then. If the instructions manual is damaged or otherwise unusable, please
contact and order a new one from:
Kellfri AB, Munkatorpsgatan 6, 532 37 SKARA, Sweden
Phone: [phone]
The general safety instruction is also available from Kellfris website: manual.kellfri.co.uk
Do not use this equipment if you are feeling sick, tired or in inuence of alcohol. Nor if you
are under the inuence of strong medications or drugs, suering from strong depression or
severe mental illness.
TECHNICAL DATA 28-TH6P
H ×D ×W 1300 mm 770 mm 685 mm
Diameter Tube 25 mm
Weight 14,5 kg
Warning! Compliance with the safety instructions requires that the product is only
used as described in these instructions. It is the user’s responsibility to read
through the instructions and comply with them.

3
PRODUCT SAFETY INFORMATION
Read the instruction manual carefully before installing the product.
The product must only be used as described in this instruction manual.
IN CASE OF EMERGENCIES
In case of an emergency please dial 112.
PERSONAL PROTECTIVE EQUIPMENT
Always use appropriate protective equipment. Always use appropriate protective equipment
when installing the product.
BEFORE USE
Read the instruction manual carefully. Be sure that you understand the safety information,
instruction manual and warning decals. Use common sense when using the product.
Check that the wall where the rack is going to be installed is strong enough to carry heavy
weight. Bear in mind the weight of each blanket specially when thet are wet. Make sure that
the wall have enough support.
STORING
Always keep the tool or product in a dry place, preferably under cover when not in use. Make
sure that the equipment or product is stable and not likely to tip over. Never let children play
at the storage site. Keep in mind the risk of crushing.
MAINTENANCE AND SERVICE
Make sure the equipment is stable and not likely to fall during maintenance and service.
Replace damaged and worn parts immediately to reduce the risk of injury.
Perform maintenance, servicing and inspections according to the recommendations.
RECYCLING
Disposal of the product, the machine should be disassembled and transported to the
municipality recycling station. Contact your municipality for further information.
upper bracket
lower bracket
686 760
1267
1353
ASSEMBLY OF THE PRODUCT AND INSTALLATION
Check your wall space and nd a suitable location
for the equipment. The upper and lower brackets are
screwed to the wall, x the racks in the brackets. (See
the images below)
blanket racks

EGFÖRSÄKRAN OM MASKINENS ÖVERENSTÄMMELSE, ORIGINAL
EC-DECLARATION OF CONFORMITY
According to 2006/42/EC, Annex 2A
Kellfri AB
Munkatorpsgatan 6
532 37 Skara, Sweden
Declares that the product
Name: 28-TH6P
Type: Blanket rack
Complies with all applicable provisions of the directive 2001/95/EG
Other equipment must meet the hardware requirements of the Directive.
Tina Baudtler, Representative
2016-11-15
WARRANTY TERMS AND CONDITIONS
Validity of the warranty - Kellfri’s Warranty is valid  months from the date of purchase.
This warranty replaces - Compensation for spare parts after acknowledgment that the
fault lies on the material or manufacturing defects.
This guarantee do not
cover
• Labour costs
• Travel expenses
• Any modication that the buyer himself has/had made.
• Any consequential damages that occurred due to damage to
the machine.
• Damage due to normal deterioration of the machine, inad-
equate: service, user inexperience or use of spare parts which
are not original.
• Wear parts such as hoses, seals, oils, and mechanical belts
Kellfri AB is constantly working on further developing their products and therefore reserves the right
to modify, among other things the design and appearance without further notice.
CUSTOMER SERVICE
You are always welcome to give your feedbacks, reviews or ask us about our tools and products.
Kellfri AB
Phone: [phone] - 242 50
Fax: [phone] - 168 33
Email: [email protected]