Kenmore 27" (68.8) User manual

Convection Microwave Oven Installation Instructions
Installation and service must be performed by a qualified installer.
IMPORTANT: Save for local electrical inspector's use.
Read and Save these instructions for future reference.
The electrical requirements for this oven are 120 volts, 15 amps.
NOTE
1. Base must be capable of supporting 150 pounds (68.0 kg)
for the Convection Microwave Oven only.
2. Make sure base is level and front of cabinet is square. If
the cabinet base is not level, the oven will tend to slide out
when opening the door.
3. Minimum required distance is 36" (91.44 cm) from the
floor.
4. The outlet should not be located in the shaded area of
Figure 1. It is required the outlet be a dedicated 120 volts
with a 15amp rating for the appliance.
5. Minimum required distance between the Microwave Oven
and the wail oven cutouts should be at least 3 inches. The
actual visible space will be reduced due to the overlap of
the Microwave Oven lower vent and the wail oven.
Figure 1
Product Dimensions
Model A B C D
27" (68.8) 27" (68.8) 213¼" (55.3) 247/8" (63.2) 203¼" (52.6)
30" (76.4) 30" (76.4) 213¼'' (55.3) 28" (71.1) 203¼" (52.6)
Cutout dimensions and cabinet width
Model Min. FMax. GMin. HMax. [
27" (68.8) 251/8'' (63.8) 255/8'' (65.1) 24" (61.0) min. 21" (53) 211/2" (54.6) 27" (68.8) min.
30" (76.4) 281/2 '' (72.4) 29" (73.7) 24" (61.0) min. 21" (53) 211/2'' (54.6) 301/8 '' (76.5) min.
All dimensions are in inches (cm).
P/N 316902472
TINSEB527MRRO
1 E

Convection Microwave Oven Installation instructions
IMPORTANT NOTES TO THE INSTALLER
.
Read all instructions contained in these installation
instructions before installing the Convection Microwave
Oven. This oven can be built into a cabinet or wail
by itself or above any electric wail oven or warming
drawer.
Remove aii packing material from inside the oven
cavity before connecting the electrical supply to the
Convection Microwave Oven. DO NOT REMOVE THE
WAVEGUIDE COVER, which is located on the cavity
ceiling. See Figure 2A.
Waveguide Cover_
Oven Cavity
Door Seals
and Sealing
Surfaces
Hinge
Safety
Door Latch ,_
Figure 2A Figure 2B
3. Remove the 2 shipping duct supports (see Figure 2B) by
removing the 2 screws securing each side. Reinsert 2
screws (each side) to secure the stainless cover.
4. Remove the feature sticker, if there is one, from the
outside of the door.
.Check the oven for any damage, such as misaligned or
bent door, damaged door seals and seaiiing surfaces,
broken or loose door hinges and latches and dent inside
the cavity or on the door.
If there is any damage, do not operate the oven and
contact your dealer or KENMORE AUTHORIZED SERVICER.
6. Observe all governing codes and local ordinances.
7. Be sure to leave these instructions with the consumer.
iMPORTANT SAFETY
iNSTRUCTiONS
Never use your appliance for warming or heating the room.
Prolonged use of the oven without adequate ventilation can
be dangerous.
CARPENTRY
Refer to Figure 1for the dimensions required for your
appliance, and the space necessary to install the oven. The
oven support surface should be solid plywood or similar
material, the surface must be level from side to side and
from front to rear.
ELECTRICAL REQUIREMENTS
The appliance operates on a 120 volt, 60 Hz electrical
supply with a separate ground wire. Provide a separate
circuit with a fuse or circuit breaker rated for 15 amps.
Observe all governing codes and local ordinances
To prevent damage to the oven control, during cold
temperature weather, wait at least three (3) hours
after receiving this oven before supplying power to the
appliance. This will prevent possible damage to the built-in
oven control at power on.
CABINET INSTALLATION
The Convection Microwave Oven can tip when the door is
open. The Anti-Tip brackets supplied with the Convection
Microwave Oven must be attached to the cabinet and
the appliance to prevent tipping of the unit and injury to
persons.
IMPORTANT NOTE TO THE CONSUMER
Keep these instructions with your Owner's Guide for future
reference.
ANTI-TIP BRACKETS INSTALLATION INSTRUCTIONS
1. Unpack the Convection Microwave Oven and find the
2 Anti-Tip brackets and screws included in the literature
package.
2. Install the Anti-Tip bracket in the cabinet as shown
on Figure 3. Note: To prevent damage to cabinet, it is
recommended to drill 1,_6"(0.16 cm) diameter pilot holes
before installing the Anti-Tip brackets.
E2

Convection Microwave Oven Installation instructions
CONVECTION MICROWAVE OVEN iNSTALLATiON
Two persons are required to install the oven. Never hold the
door handle when moving the oven.
3. Place the oven adjacent to the opening on a table or
stand. Hug the power supply cord into the electrical
outlet. Carefully guide the oven into the prepared
opening. Avoid pinching cord between oven and
wall. See Figure 4. Push the unit in and against the
cabinet. The oven side bracket will dip into the Anti-Tip
brackets. See Figure 3.
4. To pull out the oven for servicing_ open the door and
locate the two holes on the side frame. Simultaneously
insert the tools provided with the appliance in both
holes and pull the oven towards you. See Figure 5.
ANTI-TIP BRACKET iNSTALLATiON
Cutout Width
(See dimensions below)
,I
ckets j
16-1/2"
(41.9cm)
Cutout Height
21" (53.3 cm) Min. _
21-1/2" (54.6 cm) Max. _
= ......
Figure 3
27=INCH Cutout Width
251/8" (63.8 cm) Min. _
25 5/8" (65.1 cm) Max. _
25 3/8" (64.5 cm) Recommended _
30-1NCH Cutout Width
281/2" (72.4 cm) Min. _
29" (73.7 cm) Max. _
28 3¼"(73.0 cm) Recommended _
FINISHED ANTI-TIP BRACKET INSTALLATION REMOVING OVEN FOR SERViCiNG
Figure 4Figure 5
3 E

Convection Microwave Oven Installation Instructions
MODEL AND SERIAL NUMBER LOCATION
The serial plate is located on the oven front frame. See
Figure 6.
When ordering parts for or making inquires about your
oven_ always be sure to include the model and serial
numbers and a lot number or letter from the serial plate on
your oven.
PRODUCT IDENTIFICATION
BEFORE YOU CALL FOR SERVICE
Read the Before You Caii for Service Checklist and
operating instructions in your USE AND (:ARE GUIDF.
It may save you time and expense. The list includes
common occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to the warranty in your USE AND (:ARE GUIDI: for
our service phone number and address. Please caii or write
if you have inquiries about your product and/or need to
order parts.
Serial
Menu
Figure 6
E 4