KRC-225/235/265/265S
5
MICROCOMPUTER'S TERMINAL DESCRIPTION
Pin No. Pin Name I/O Description Processing Operation
1 XIN I Main clock resonator connection terminal
2 GND - TEST terminal 2 Connected to GND lines.
3 L DATA L I Data input from the LCD driver IC
4 L DATA S O Data output to the LCD driver IC
5 L CLK O Clock output to the LCD driver IC
6 L CE O CE output to the LCD driver IC
7 SDA I/O Data input/output with the E-VOL. IC
8 PLL DATA I/O Data input/output with the F/E
9 PLL CLK O Clock output to the F/E
10 SD I SD input from the F/E Hi : Station detected
11 DATA C I Data input from changers
12 DATA H O Data output to changers
13 CH CLK I/O Clock input/output with changers
14 - O - N.C.(Not used)
15 MOTOR O Cassette motor on/off output Hi : Motor ON
16 SCL O Clock output to the E-VOL. IC
17-24 - O - N.C.(Not used)
25 AM+B O AM+B ON/OFF output Hi : during AM reception
26 FM+B O FM+B ON/OFF output Hi : during FM reception
27 PACK IN I Cassette tape Pack-in detection input Lo : Pack-in
28 FF/REW I FF/REW detection input Lo : FF/REW, Hi : PLAY
29 GND I - Connected to GND lines.
30 GND I - Connected to GND lines.
31 VDD - Positive power supply connection terminal Connected to B.U. 5V lines.
32 REQ C I Request input from changers Lo : Request
33 MUTE O Audio mute on/off output Hi : Mute ON
34 CH CON O Changer control Lo : Standby, Hi : ON
35 REQ H O Request output to changers Lo : Request
When the momentary power down, after ACC
36 SVR O Power IC reset terminal ON/OFF is detected and after POWER OFF,
the output becomes Hi temporarily.
37 AMP STBY O Power IC standby control output Hi : POWER ON mode
38 AMP MUTE O Power IC mute control Lo : Mute
39 P CON O Power control Hi : POWER ON mode
40 ANT CON O Antenna control Hi : during FM/AM reception
41 SW5V O SW 5V control Lo : POWER ON mode
42 ILL O Illumination AVR ON/OFF control terminal Hi : POWER ON mode
43 - O - N.C.(Not used)
44 BEEP O BEEP sound output
45-47 - O - N.C.(Not used)
48 ROLL OFF I Roll off input Pull down to GND lines. (Not used)
49 NOISE I Noise canceller input Pull down to GND lines. (Not used)
CANCELLER
50 SEL1 I Destination input 1 Lo : KDC-225, Hi : KDC-235,265/S
51 SEL2 I Destination input 2 Lo : KDC-265/S, Hi : KDC-225,235
52 SEL3 O Destination input 3 N.C.(Not used)
53 EQ MUTE O Tape equalizer mute on/off output N.C.(Not used)
54 FWD/REV I FWD/REV mode detection input Lo : REV mode
55 - O - N.C.(Not used)
56 REMO I Data input from the remote control KDC-225/235:Pull up to PON5V lines. (Not used)
light sensor KDC-265/S:Pull down to GND lines. (Not used)
57-60 - O - N.C.(Not used)
¶Terminal Description ( IC1 : X14-6850-XX)
