BLK
TURN THE POWER OFF
A) Configure drive Master/Slave jumper settings.
NOTE: This Quick Install Guide is for
experienced users only!
For less experienced users, please refer to the
installation sections of your User’s Guide.
CD-ROM Master/Slave
Channel Devices Connected Jumper Configuration
Primary Main hard disk connected
(always set to MASTER) Slave
Secondary No devices connected Master
Secondary A single device connected as the MASTER Slave
Primary No IDE hard disk drive present (HDD is SCSI,
Fibre Channel, etc.) Master
Tertiary (if available)* No devices connected Master
*NOTE: Some add-in boards like sound cards have a single EIDE channel available. If this is your only
option, please consult your add-in board documentation regarding its use.
INSTALL YOUR KENWOOD 72X OR 62X TRUEX CD-ROM DRIVE
INTO AN AVAILABLE 5.25" HALF-HEIGHT DRIVE BAY
INSTALLATION
COMPLETED!
Congratulations—your Kenwood
drive should be successfully
installed. If there are problems
accessing the drive, refer to the
Troubleshooting section in your
User’s Guide, or on our web
site at www.kenwoodtech.com.
If you are still having problems,
please call our technical support center at 1-888-730-4206
IDE cable
Audio connector
Power cable
CONNECT CABLES TO THE KENWOOD DRIVE
Your Kenwood drive will
automatically be detected
by Windows® 95
or higher.
