
Page 2 of 4
THANK YOU!
Thanks for choosing Keyscaper! This manual will get you started playing music on your Blue-
tooth speaker. If you don’t know how to set up Bluetooth on your smartphone, laptop, tablet
, or whatever other source device you’re trying to connect to the speaker, you may need to
refer to your source device’s manual for more information.
CHARGING:
Before you use your speaker for the rst time, you should charge it fully. Don’t worry if you
got excited and started using it right away – everything will be ne.
• To charge your speaker, you need to use a USB MINI cable (included) to plug the
speaker into a standard USB port on a computer or wall charger. As soon as you
plug it in, the red power LED on top will come on.
• Fully charging the speaker will take about 4 hours. The red power LED will turn
blue to indicate a full charge. It’s tough to wait that long before you start rocking
out, but it is the best thing to do for the batteries in the long run.
CONNECTING:
Now that charging is out of the way, connecting your speaker to your device is easy. However,
you may need your source device’s Bluetooth syncing instructions in addition to this manual in
case you get stuck.
• Press and hold the power button on top of the speaker for three seconds to turn it
on. The power LED will glow red briey and Bluetooth Button next to it will begin
to slowly ash.
• Put your source device in Bluetooth paring mode. This is typically done from the
settings menu or Bluetooth device manager. Here is where you may need your
source device’s manual for further help.
• Place your Keyscaper Bluetooth Speaker in pairing mode by pressing the Blue-
tooth button on top and holding it for about four seconds. You will hear two beeps
and the Power and Bluetooth buttons will ash alternately.
• Look at your source device. You should now see a listing for “Keyscaper” in the