CAS Registry Number(R) is a Registered Trademark of the American Chemical Society Form enabled by Adobe
Save the fields in
this form to a file
Import fields from a
file into this form
Clear all of the
fields on this form
Lock the fields on this
form to prevent changes
RoHS Definition: Quantity limit of 0.1% by mass (1000 PPM) in homogeneous material for: Lead (Pb), Mercury, Hexavalent Chromium, Polybrominated Biphenyls (PBB),
Polybrominated Diphenyl Ethers (PBDE) and quantity limit of 0.01% by mass (100 PPM) of homogeneous material for Cadmium
RoHS Material Composition Declaration
Exemptions: If the declared item does not contain RoHS restricted substances per the definition above except for defined RoHS exemptions, then select the corresponding response in the RoHS Declaration
above and checkboxes will appear below. Check all applicable exemptions.
1. Mercury in compact fluorescent lamps not exceeding 5 mg per lamp.
7c. Lead in electronic ceramic parts (e.g. piezoelectronic devices).
2a. Mercury in straight fluorescent lamps for general purposes not exceeding 10 mg. in
halophosphate lamps
8. Cadmium and its compounds in electrical contacts and cadmium plating except for applications
banned under Directive 91/338/EEC amending Directive 76/769/EEC relating to restrictions on the
marketing and use of certain dangerous substances and preparations piezoelectronic devices).
2b. Mercury in straight fluorescent lamps for general purposes not exceeding 5 mg. in triphosphate
lamps with a normal lifetime
9. Hexavalent chromium as an anti-corrosion of the carbon steel cooling system in absorption
refrigerators
2c. Mercury in straight fluorescent lamps for general purposes not exceeding 8 mg. in triphosphate
lamps with long lifetime
10a. Deca BDE in polymeric applications
3. Mercury in straight fluorescent lamps for special purposes.
10b. Lead in lead/bronze bearing shells and bushes
4. Mercury in other lamps not specifically mentioned in this list.
11. Lead used in compliant pin connector systems.
5. Lead in glass of cathode ray tubes, electronic components and fluorescent tubes.
12. Lead as a coating material for a thermal conduction module c-ring.
6a. Lead as an alloying element in steel containing up to 0.35% lead by weight.
13a. Lead in optical and filter glass.
6b. Lead as an alloying element in aluminum containing up to 0.4% lead by weight.
13b. Cadmium in optical and filter glass.
6c. Lead as an alloying element in copper containing up to 4% lead by weight.
14. Lead in solders consisting of more than two elements for the connection between the pins and the
package of microprocessors with a lead content of more than 80% and less than 85% by weight .
7a. Lead in high melting temperature type solders (i.e. lead based solder alloys containing 85% by
weight or more lead).
15. Lead in solders to complete a viable electrical connection between semiconductor die and carrier
within integrated circuit Flip Chip packages.
7b. Lead in solders for servers, storage and storage array systems, network infrastructure equipment
for switching, signalling, transmission as well as network management for telecommunications.
Instructions: Complete all of the required fields on all pages of this form. Select the "Accepted" on the Supplier Acceptance drop-down. This will display the signature area. Digitally sign
the declaration (if required by the Requester) and click on Submit Form to have the form returned to the Requester.
Supplier Digital Signature
