KICK ASS POWERBOOST 1500 User manual

USER MANUAL
KAJUMPSTRTR V1.0
POWERBOOST 1500
LITHIUM JUMP STARTER

ŸBattery: 74Wh Lithium ion
ŸUSB C PD Output: 5V/3A, 9V/3A, 12V/3A, 15V/3A, 20V/3A 60W
Max
ŸUSB C PD Input: 5V/3A, 9V/3A, 12V/3A, 15V/3A, 20V/3A 60W
Max
ŸUSB A Output 1: 9V/2A 18W Max
ŸUSB A Output 2: 5V/2.4A 12W Max
ŸStart Current: 1500A.
ŸPeak Current: 3000A
PRODUCT SPECIFICATIONS
IMPORTANT SAFETY INFORMATION
ŸFully charge the unit before first use or if the unit has not been
used for a long time.
ŸTo maximize battery life, it is highly recommended that you fully
charge your battery every three months.
ŸDo not attempt to disassemble or replace the battery or batteries.
ŸThis unit is not intended to be used by people with reduced
physical, sensory, or mental capabilities or those who lack
experience and knowledge.
ŸChildren must always be supervised around this unit.
ŸWhen charging the unit, DO NOT expose it to open flames or
cigarettes.
ŸDO NOT insert foreign objects into the input and output ports.
ŸDO NOT move the unit if it is being charged or while it is in use.

ELECTRICAL SHOCK
ŸThis product is an electrical device and can cause electric shock
or serious injury.
ŸDo not cut power cords.
ŸDo not expose the unit to rain or excessive moisture or submerge
in water.
DANGER
EXPLOSION
ŸDo not attempt to jump start a damaged or frozen battery.
ŸUse the product only with batteries of the recommended voltage.
ŸUse the product only in well-ventilated areas.
FIRE
ŸThis product is an electrical device. It emits heat and can cause
burns.
ŸDo not cover the product.
ŸDo not smoke or allow any source of electrical spark or fire during
operation.
ŸKeep the product away from combustible materials.
EYE INJURY
ŸWear eye protection when operating the product.
ŸBattery acid can cause eye and skin irritation.
ŸIn the case of contamination of eyes or skin, flush affected areas
with running clean water and contact poison control immediately.
EXPLOSIVE GASES
ŸBatteries generate explosive gases during normal battery
operation.
ŸTo reduce the risk of battery explosion, follow all safety
information instructions and those published by the battery
manufacturer.
ŸReview the warning labels on these products and your engine.

UNDERSTANDING YOUR DEVICE
TO RECHARGE YOUR DEVICE
The Powerboost 1500 Lithium Jump Starter contains a 74Wh lithium
battery pack. Charge the product with the included 60W silicone
cable and a PD 60W wall adapter (not included) or a PD car charger
(not included).
Note: Fully charge the battery at least once every three months.
Overloading the battery or storing it for too long without
charging it may cause permanent damage.

HOW TO USE THE DEVICE
Step 1: Charge the Powerboost 1500 Lithium Jump Starter.
ŸThe Powerboost 1500 lithium jump starter comes partialy charged
out of the box and needs to be fully charged prior to first use.
ŸWe recommernd not charging and discharging the unit at the
same time.
ŸThe time to recharge the unit will depend on the power supply
used.
ŸAs a guideline, a PD 60W wall adapter takes approximately 50
minutes to charge from 0 to 80%.
Step 2: Connect to the battery.
ŸConnect the battery clamps to the unit by connecting to the 12V
out port.
ŸConnect the positive (red) battery clamp to the positive (+) battery
terminal.
ŸConnect the negiative (black) battery clamp to the negative (-)
battery terminal or vehicle chassis.
ŸWhen disconnceting, disconnect in the reverse sequence,
removing the negative first .
Step 3: Jump starting
ŸBefore beginning, make sure all the vehicle’s power loads are
turned off before attemtping to jump start the vehicle.
ŸTurn on the power button.
ŸTry starting the vehicle. Most vehicles will immediately start.
Some vehicles may take up to 30 seconds before stargting.
ŸIf the vehicle does not start right away, wait 30 seconds and try
again.
ŸDo not attempt more than three consecutive jump starts within a
15 minute period.
ŸAllow the Powerboost 1500 to rest for 15 minutes before
attempting to jump start the vehicle again.
ŸOnce your have started your vehicle, disconnect the cable clamps
and remove the Powerboost 1500.

CLEANING INSTRUCTIONS
ŸBefore cleaning, ensure the unit is switched off and disconnected
from the power supply.
ŸClean with a damp cloth only.
ŸDo not use any abrasive cleaners or harsh chemicals.
ŸEnsure all components are completely dry before storing the unit.
BE AWARE
ŸIf the Powerboost 1500 temperature climbs higher than 55
degrees or lower than -10 degrees, the unit will immediately stop
and a warning icon will flash at 1 second intervals.
ŸThe Powerboost 1500 is designed with 100% maximum safety
protection. Manual override (removing all protections) to force
jump start engines is not possible.
ŸThe Powerboost 1500 is designed to jump start 12V lead acid
batteries down to 2V only.

Kickass is a registered trademark of
Kickass Products Pty Ltd
Designed & imported by
Kickass Products Pty Ltd
39 Iris Place, Acacia Ridge, QLD 4110
Australia
Made in China