Kidco Auto Close Configure Gate G4300 User manual
USER GUIDE G4300/G4301 G4310/G4311
3
and HearthGate
™
AutoClose ConfigureGate
™
1
2
3
1To add/connect sections, place hinge
posts over the center of the next section’s
hinge receivers and press down until a click
is heard. Continue adding more sections the
same way.
2Once all sections have been assembled
lift all locking caps into the raised unlocked
position (a) and adjust the angle of each
section until desired configuration is achieved
(b). Push down on all locking caps (c).
3To remove a section, place thumb and
index finger inside upper hinge post and
pinch while lifting.
NOTE: The walk through door section can
be positioned anywhere within the layout
of the gate.
Assembly
(a)
(c)
(b)
If you’re looking for quality home furniture & decoration, visit our website.
This manual suits for next models
3
Table of contents
Other Kidco Fencing & Gate manuals
