Kiddicare Anna Dropside Cot User manual

ANNA
DROPSIDE COT

RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY
This cot should be assembled by an adult. Please note that this is a heavy cot which will be more
easily assembled with the help of an assistant
AEnd frame (2)
BSide frame with end pins (dropside) (1)
CSide frame (fixed) (1)
DBase (1)
E Allen key (1)
F Bolt (8)
G Cylindrical insert (8)
LIST OF PARTS 1
IMPORTANT
ABC
D
EF G
TO ASSEMBLE THE BASE 2
D
A
G x 4
F x 2
Push the cylindrical
inserts (G) into the
holes in the side
frame (C) and base
(D) ensuring that the
screwdriver slot in the
end of the inserts faces
outward and aligns with
the hole as shown.
NOTE:
DO NOT FULLY TIGHTEN
BOLTS AT THIS STAGE

1
2
3
FULLY TIGHTEN ALL BOLTS.
Your cot is now ready for use.
To operate the Dropside;
Grasp the top rail in the centre and lift slightly.
Press the bottom of the dropside in with your leg - this
will disengage the locks and allow the side to drop. To
raise the side, simply lift until it clicks into place.
IMPORTANT: Always grasp the top rail in the centre to
ensure that both locks engage and disengage.
TO FIT AND OPERATE THE DROPSIDE 4
A
B
B
A
TO ASSEMBLE THE SIDE FRAME 3
G x 4
F x 2
C
NOTE:
DO NOT FULLY TIGHTEN
BOLTS AT THIS STAGE
F x 4

The bed base can be adjusted in height, but the lowest position is the safest and should always be
used in that position as soon as the baby is old enough to sit up.
The cot is suitable for a mattress of 1200mm in length and 600mm in width and a maximum
thickness of 100mm. The length and width shall be no less to ensure the gap between the mattress
and the sides and ends does not exceed 30mm.
The thickness of the mattress shall be such that the internal height (surface of the mattress to the
upper edge of the cot frame) is at least 500mm in the lowest position of the cot base and at least
200mm in the highest position of the cot base.
If you leave the child unattended in the cot, always make sure that the dropside is in the raised
position.
To prevent injury from falls the cot should no longer be used for the child once they are able to
climb out of the cot.
A light application of a wax polish to the dropside grooves in the end panels will aid operation.
IN USE 5
CARE AND MAINTENANCE 6
This cot has been designed and manufactured to BS EN 716-1: 2008
Warning: Do not use the cot if any part is broken, torn or missing and use only spare parts
approved by the manufacturer.
Warning: Do not leave anything in the cot or place the cot close to another product, which could
provide a foothold or present a danger of suffocation or strangulation, e.g. strings, blind/curtain
cords, etc.
Warning: Do not use more than one mattress in the cot.
Warning: Be aware of the risk of open fires and other sources of strong heat, such as electric bar
fires, gas fires, etc. near the vicinity of the cot.
WARNING
YOUR CHILDREN’S SAFETY
IS YOUR RESPONSIBILITY
All assembly fittings should be tightened properly and should be checked regularly and re-tightened
as necessary.
To clean use a damp cloth, avoiding the use of strong detergents or abrasives.
An occasional light application of a wax polish will help maintain a good appearance.
07774
Customer care hotline for this product 01692 408802
kiddicare.com
Club Way
Cygnet Park
Hampton
Peterborough
Cambs
PE7 8JA
www.kiddicare.info