KiloVault BE24 User manual

Revision: 1.03
5/6/2020
KiloVault® BE24 Battery Equalizer Instructions
APPLICATION
Battery equalizer BE24 is intended for use with a
connected series of 12V lead-acid batteries to
maintain battery voltage balance. This includes Gel,
Flood, Lithium Iron Phosphate batteries (LFP), and
AGM lead-acid batteries.
When two or more in-series connected batteries
develop a voltage difference of 20mV or more, the
battery equalizer will shunt current from the higher
voltage battery to the lower voltage battery until
the voltage equalizes. This improves performance
and extends battery life.
Battery equalizer BE24 can be used for 24V, 36V,
48V and any other N*12V battery system.
•1 piece for 24V system
•2 pieces for 36V system
•3 pieces for 48V system
TECHNICAL DATA
TECHNICAL DATA
Battery Nominal Voltage
2*12
Optimizing
Current
0-5A
Quiescent
Current
<3mA
Dimensions
70x70x27 mm
Protection
Reverse polarity
protection
Low Voltage Disconnect
10V
LED INDICATOR
LED Indicator
LED (A)
LED (B)
V(A)=V(B)
Off
Off
V(A)>V(B)
Flash
Off
V(A)<V(B)
Off
Flash
V(A)<10V
On
Off
V(B)<10V
Off
On
V(A&B)<10V
On
On
•The LED indicators work using the working
voltage of the batteries
INSTALLATION
Simply connect the red cables to the positive (+)
terminals and the black cables to the negative (–)
terminals. Be sure to connect all positive (+)
connections before the negative (–) connections to
avoid short circuits. Batteries may be connected in
series or in parallel.
Note:
•If there are unused cables, leave the protective
terminal tubes in place to avoid short circuits.
•Do not allow any of the eight terminals touch
each other.
CONTACT US
Email: [e-mail]
Phone: [phone]
https://kilovault.com/
KiloVault, LLC
330 Codman Hill Road
Boxborough, MA 01719

Revision: 1.03
KiloVault® LLC • 330 Codman Hill Road, Boxborough, MA 01719 • [phone] • [email protected] • www.kilovault.com
CONNECTION EXAMPLES
Figure 1: 24V battery bank of 2 batteries
Figure 2: 24V battery bank of 4 batteries
Figure 3: 36V battery bank
Figure 4: 48V battery bank