Kingdar VAST SYSTEM Manual

VAST SYSTEM
How to Build a Workstation?

1. To fit the bottom post kit.
1
To insert the post kit into the groove of post and push it down.
2. To fit the bottom panels, and make the posts stand.
(1) To insert the clamps of panel into the groove of post
and push the panel down.
(2) To fit all the bottom panels to make the posts stand.

3. To put the H-shape stick between the panels.
2
To put the H-shpae stick into the top of the panel.
(If the width of the panel is under 100cm, use 1 stick;
and if the width of the panel is over 100cm, use 2 sticks. )
4. From bottom to top, fit all the panels.
When you fit the top of panel, insert the top from side of the panel.
5. To fit the top post kit.
To insert the post kit into the groove of post, fill all the empty grooves.
* FG, FR, and BS don’t need it.

6. To fix the brackets of worktop.
3
(1) To insert the worktop bracket
into the track of post.
(2) To fix the screw, and the top of
the bracket to the end of the
track is 69 cm.
69cm
(3) To fix the brackets of side panel then fix the side panel,
and fix all the worktop brackets.

7. To fix the inside cap of post.
4
To use the electrical screw driver to lock up the inside cap of post.
8. To fit the cap of post.
To put the cap of post on the top of the post.
9. To fix the worktop.
(1) First, use the electrical screw driver to lock up the single leg to
the worktop.

5
(2) To use the electrical screw driver to lock up the worktop
bracket and fix the worktop.
10. To fit the cover of raceway panel.
(1) To hook the cover of raceway
panel to the frame.
(2) To push the cover of raceway
panel forward, make it clip
with the frame.
(3) Done!

6
11. The workstation is finished!