KingtronicRF PKE-C801 Installation instructions

PKE-C801
Keyless Entry System With Car Alarm
Installation & Operation Instructions
Kingtronic RF Corp. www.kingtronic.tw [email protected]
1

PKE-C801 Keyless Entry System With Car Alarm
Installation & Operation Instructions
PKE-C801 – Keyless Entry System with Car Alarm System offers convenience and
security in one package.
Convenience Features: The PKE-C801 includes keyless entry. This will allow you
to lock and unlock your car doors on vehicles equipped with power door locks. The
remote trunk release feature is handy as well allowing you to open your cars trunk
via the remote control.
Security Features: The system will protect your vehicle in several ways. When
vibration is detected via the included shock sensor the siren will sound and parking
light will flash. If the doors, trunk or hood are opened while the system is armed the
alarm will sound as well. To prevent against theft the system includes a starter
disable relay and output. This feature will defeat the starter signal of your vehicle
when the alarm is armed. For added security you can also add a car alarm pager to
the system. The pager will notify you at greater distances if your vehicle is violated.
System contents：
1 Main Unit 1
2 Smart Card W/Remote Control 2
3 Antenna Module 3
4 Wire Set 1
5 Installation l & Operation Instructions 1
Transmitter Function: (Smart Card)
SWITCH AUTO/RKE FUNCTION
AUTO: KEYLESS ENTRY W/AUTO LOCK/UNLOCK
RKE : REMOTE CONTROL
ARM/LOCK
TRUNK OPEN
DISARM/UNLOCK
2

Main Unit ：
P.S. Lock/Unlock, Trunk open, Siren output (+) positive or (-)negative can adjust for
your different vehicle. Just change the PIN position.
Installation：
3

Operation Instructions：
A. System Power ON：
Confirmed vehicle’s door closed then connect the wire harness to the Main Unit
after all wiring to vehicle is complete. LED ON and enter the disarming mode.
B. Programming Transmitter：(＊Factory Default Setting)
(2-programming method)
The system state 1. Disarming
2. Door Unlock
3. Ignition OFF.
4. AUTO or RKE
Programming method I ：
Enter ：
1. Turn Ignition to “ON” position.
2. Press the switch 3 sec until LED flash 3-time then release the switch. You are
now in the Transmitter programming mode.
Program ：
1. Press any button on the transmitter unit the siren responds with a
confirming chirp and transmitter’s LED flash once. The first transmitter is
now programmed.
2. Press button on the second transmitter until the siren responds with
2-confirming chirp and transmitter’s LED flash once. The second transmitter
is now programmed.
3. Apply the same procedure to program 3rd 、4th、and 5th transmitter.
Exit ：
1. Programming less than 5 sets code. Turn Ignition to “OFF” position,
2. Programming 5 sets code the system automatic exit the programming mode
after complete ed program.
3. If more than 5 transmitters programmed, the system only kept last 5
transmitters.
Programming method Ⅱ：
Enter ：
1. When the door closed. Open/Close door twice kept door closed. After 2
second turn to Ignition switch “OFF/ON” 4 times and stay in “ON” position.
2. After 3-short chirp is hearing. You are now in the Transmitter programming
mode.
Program ：
1. Press any button on the transmitter unit the siren responds with a
4

confirming chirp and transmitter’s LED flash once. The first transmitter is
now programmed.
2. Press button on the second transmitter until the siren responds with
2-confirming chirp and transmitter’s LED flash once. The second transmitter
is now programmed.
3. Apply the same procedure to program 3rd 、4th、and 5th transmitter.
Exit ：
1. Programming less than 5 sets code. Turn Ignition to “OFF” position,
2. Programming 5 sets code the system automatic exit the programming mode
after complete ed program.
3. If more than 5 transmitters programmed, the system only kept last 5
transmitters.
Note: Factory default setting , If user need programming transmitter again.
Please confirmed vehicle’s door closed and within 5 seconds turn ignition to
“ON” position.
B. Active Arming – Lock & Arm
The system state --AUTO
1. Disarming
2. Door Unlock
3. Ignition OFF.
4. AUTO
1. Transmitter is on AUTO state (Keyless entry function; auto-lock/unlock door)
2. When transmitter exceeded the compass of area around the vehicle
2-meters over 5 seconds.
3. The siren/horn will chirp once and parking light will flash once to indicating
that the system is now armed. The vehicle’s door will lock upon arming.
The system state --RKE
1. Disarming
2. Door Unlock
3. Ignition OFF.
4. RKE
1. Transmitter is on RKE state (Remote control function)
2. Press button on transmitter.
3. The siren/horn will chirp once and parking light will flash once to indicating
that the system is now armed. The vehicle’s door will lock upon arming.
5

C. Active Disarming – Unlock & Disarm
The system state --AUTO
1. Arming
2. Door lock
3. Ignition OFF.
4. AUTO
1. Transmitter is on AUTO state (Keyless entry function; auto-lock/unlock door)
2. When user take transmitter into effective range around the vehicle 2-meters.
3. The siren/horn will chirp twice and parking light will flash 2-times to
indicating that the security system is now disarmed. The vehicle’s door will
unlock disarming.
The system state --RKE
1. Arming
2. Door Lock
3. Ignition OFF.
4. RKE
1. Transmitter is on RKE state (Remote control function)
2. Press button on transmitter.
3. The siren/horn will chirp twice and parking light will flash 2-times to
indicating that the security system is now disarmed. The vehicle’s door will
unlock disarming.
D. Trigger the system
The system state
1. Arming
2. Door Lock
3. Ignition OFF.
4. AUTO/RKE
When armed, your vehicles is protected as follows：
1. Light impacts will trigger the warn-away signal. 3-times short chirp from
siren/horn. Continue to 3-cycle.
2. Heavy impacts/Door open/Hood open/Trunk open/Vibration(vehicle
oblique)/Turn ON the Ignition switch will trigger the programmed sequence.
3. Alarm continue 25 seconds from siren/horn then stop 2 second. Parking light
flash once interval of 0.5 second. Continue to 5-cycle.
6

E. Auto-Lock
The system state
1. Disarming
2. Door Unlock
3. AUTO/RKE
4. Vehicle’s door closed
1. When vehicle’s driving speed over 20km/h continue 20 seconds. The vehicle’s
door will auto-lock.
2. When turn ignition switch from “ON” to “OFF”. The vehicle’s door will
auto-unlock.
The system state
1. Disarming
2. Door Unlock
3. Ignition ON
4. RKE
1. When turn ignition switch from “ON” to “OFF”. Opened the vehicle’s door and
closed door. Within 25 seconds doesn’t open the vehicle’s door or Hood. The
vehicle’s door will lock upon arming.
The system state
1. Disarming
2. Door Unlock
3. Vehicle’s door closed
4. RKE
1. After press button on transmitter . Within 25 seconds doesn’t open the
vehicle’s door or Hood. The vehicle’s door will lock upon arming.
F. Pause Transmit signal
The system state
1. Disarming
2. Door Unlock
3. AUTO
7

1. When vehicle’s Ignition switch ON position/ Door Open/Trunk Open . The Main
Unit will pause transmit signal.
2. At this situation, transmitter can not working.
G. Disarming without a Transmitter
1. If the transmitter is lost or inoperative.
2. Enter the Vehicle ,door closed and turn the ignition switch “ON” “OFF” 3
times stay in “ON” position(ON.OFF.ON.OFF.ON).
3. OPEN/CLOSE the door 3 times kept the door open
(OPEN.CLOSE.OPEN.CLOSE.OPEN). Then the security system is disarmed.
8

9