KKOLAR K915SS User manual

USER MANUAL
GAS HOB
K915SS

Contents
zCooker Description------------------------------------------------------------------------- P1
zImportant Information--------------------------------------------------------------------- P2-3
zOperation-------------------------------------------------------------------------------------- P3-4
zMaintenance and Cleaning-------------------------------------------------------------- P4-5
zTroubleshooting---------------------------------------------------------------------------- P5
zInstructions for the Installer------------------------------------------------------------ P5-6
zImportant safety requirements--------------------------------------------------------- P6-7
zInstallation------------------------------------------------------------------------------------ P7-8

1
Cooker Description
Figure 1
1.burner 6—1.75kW(127g/h) in 65 mm
2.burner 7—1.0kW(73g/h) in 45 mm
3.burner 8—1.75kW(127g/h) in 65 mm
4.burner 9—3.0kW(218g/h) in 95 mm
5.Burner 10—3.5kW(255g/h) in 132 mm
operating instructions:
button 1 is for burner 10
button 2 is for burner 6
button 3 is for burner 8
button 4 is for burner 7
button 5 is for burner 9

2
Important Information
Read the instructions before installing or using this appliance.
Children should be supervised to ensure that they do not play with the appliance.
These instructions are only valid if the country symbol appears on the appliance. If the symbol does not appear on the
appliance, it is necessary to refer to the technical instructions which will provide the necessary instructions concerning
modification of the appliance to the conditions of use of the country.
Installation
¾Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the
adjustment of the appliance are compatible.
¾The adjustment conditions for this appliance are stated on the label (or data plate).
¾This appliance is not connected to a combustion products evacuation device. It shall be installed and connected in
accordance with current installation regulations. Particular attention shall be given to the relevant requirements
regarding ventilation. Read the instructions before installing or using this appliance.
¾For LPG gases: Always use a pressure regulator exclusive for your gas cooker. The lack of pressure regulator might
cause excess of pressure and leak of gas.
¾Always check for the validity of the pressure regulator. Hose and regulator should be replaced every 5 years.
Technical specification of the pressure regulator:
i. Pressure: Refer to TECHNICAL DATA in this manual.
ii. Max. consumption: 2kg/h.
iii. Should be certified according to EN12864 and comply with local code.
¾The appliance shall be supplied with an approved hose which is certified to applicable EN standards and in conformity
with the National standards and
¾Regulations. The length of the hose shall not exceed 1.5m.For Finland not exceeding 1.2m
¾This appliance must be installed and serviced by a competent person
¾This appliance shall be installed in accordance with the regulations in force and only used in a well ventilated space.
¾Remove all packaging before using the gas cooker
¾Ensure that the gas and complies with the type stated on the rating label
¾Do not attempt to modify the gas cooker in any way
Caution: This appliance is for cooking purposed only. It must not be used for other purposes, for example room heating.
For your Safety
¾This gas cooker is designed to be operated by adults. Do not allow children to play near or with the gas cooker.
¾The gas cooker gets hot when it is in use.
¾Children should be kept away until it has cooled.
¾Children can also injure themselves by pulling pans or pots off the gas cooker.
¾CAUTION: This appliance is for cooking purposes only. It must not be used for other purposes ,for example room
heating.
When Use
¾This gas cooker is intended for domestic cooking only. It is not designed for commercial or industrial purposes.

3
¾When in use a gas cooking appliance will produce heat and moisture in the room in which it has been installed. Ensure
there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose.
¾When using the gas cooker for a long period of time, the ventilation should be improved, by opening a window or
increasing the extractor speed.
¾Do not use gas cooker if it is in contact with water. Do not operate the gas cooker with wet hands.
¾Ensure the control knobs are in the closed position when not in use.
¾In the event of the burner flames being accidentally extinguished, turn off the burner control and do not attempt to
re-ignite the burner for at least 1 min.
¾Service
¾The gas cooker should only be repaired or serviced by an authorized Service person and only genuine approved spare
parts should be used.
Environmental Information
¾After installation, please dispose of the packaging with due regard to safety and the environment.
¾When disposing of an old appliance, make it unusable, by cutting off the cable.
¾The symbol on the product or on its packaging indicates that this product may not be treated as household
waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for
the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
For more detailed information about recycling of this product, please contact your local city office, your household
waste disposal service or the shop where you purchased the product.
Operation
Lighting
Simply press the knob in, turn anticlockwise to maximum
Press the ignition device and hold the knob till the burner is ignited
Before releasing knob, ensure a flame is established,
If the burner fails to ignite, put into off position and try again.
If in case of a power failure or failure of the ignition, a match or lighting devise can be used. Care must be taken when using
this method.
The device shall not be operated for more than 15s. If after 15s the burner has not lit, stop operating the device and open the
compartment door and/ or wait at least 1 min before attempting a further ignition of the burner.
In the event of the burner flames being accidentally extinguished, turn off the burner control and do not attempt to re-ignite
the burner for at least 1 min.
"CAUTION: Accessible parts may be hot when the grill is in use. Young children should be kept away"
If you cannot light the flame even after several attempts, check the "cap" and “crown” (see diagram – figure 1) are in the
correct position. To put the flame out, turn the knob to the symbol “O”
Description: Figure2

4
1．Burner Cap
2. Burner crown
3. Burner plate
4. Ignition electrode
5.Thermocouple (SeeFigure9)
When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated
automatically.
To ensure maximum burner efficiency, you had better use pots and pans with a flat bottom fitting the size of the burner used
(see table).
Do not use rim based or convex-based vessels on the hotplate burners.
Burner Minimum Pan Diameter Maximum Pan Diameter
Wok in 132mm
Large (rapid) in 95mm
Medium (semi-rapid) in 65mm
Small (auxiliary) in 45mm
180mm
180mm
120mm
80mm
260mm
260mm
220mm
160mm
Warning: As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. If the control
knobs become difficult to turn, please contact your local service centre.
Warning: Users could not use the cooking vessels on the hotplate that overlap its edges.
Re-ignition:
If the flame is out for certain reasons, the safety device will cut off the gas power automatically. Turn the switch to " largest
flame " position, then ignite again, you should wait for 30 seconds when you do that; Due to the air in the tong, there may be
unsmooth ignition, revolve the switch to " largest flame " position and ignite again.
Maintenance and Cleaning
Before any maintenance or cleaning can be carried out, you must DISCONNECT the gas cooker from the electricity supply.
The gas cooker is best cleaned whilst it is still warm; as spillage can be removed more easily than if it is left to cool.
Control Panel
Sign ●= gas valve is shut off
Sign =largest flame
Sign =smallest flame
Sign = electric discharge for ignition
The Burners
The burner caps and crowns can be removed for cleaning. Wash the burner caps and crowns using hot soapy water, and
remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the
marks are particularly difficult to remove.
After cleaning, be sure to wipe dry with a soft cloth.
Ignition electrode

5
The electric ignition is obtained through a ceramic "electrode" and a metal electrode. Keep these components very clean, to
avoid lighting difficulties, and check that the burner crown holes are not obstructed.
Thermocouple
The thermocouple is very crucial for cutting gas supply in case of flame out during cooking, be sure to keep them in very
clean condition.
Troubleshooting
Problem
• There is no spark when lighting the gas
Corrective action
• Check that the unit is plugged in and the electrical supply is
switched on
• Check that the RCCB has not tripped (if fitted)
• Check the mains fuse has not blown
• Check the burner cap and crown have been replaced correctly,
e.g. after cleaning.
• The gas ring burns unevenly • Check the main jet is not blocked and the burner crown is clear of
food particles.
• Check the burner cap and crown have been replaced correctly,
e.g. after cleaning.
Instructions for the Installer
Overall dimensions
Width: 860mm Depth: 500mm (for model:HQ5B80**ZXA)
Cut out dimensions
Width: 824mm Depth: 474mm
Technical Data
Burner configuration
NG LPG
Injector Dia. (mm) kW Injector Dia. (mm) kW
Gas category I2H(20) I2H(20) I3B/P(30)/ I3+ I3B/P(30)/ I3+
Wok burner(double rings burner) 1.33 3.5 0.93 3.5 (255g/h)
Rapid burner 1.28 3.0 0.85 3.0 (218g/h)
Semi rapid burner 0.97 1.75 0.65 1.75 (127g/h)
Auxiliary burner 0.72 1.0 0.5 1.0 (73g/h)

6
Different models have different total heat input, please refer to page 1& page 2
Gas category
I Category
I3+（28~30/37）BE, FR, IT, LU, LV, IE, GB, GR, PT, ES, CY, CZ, LT, SK, CH, SI
I3B/P(30) LU, NL, DK, FI, SE, CY, CZ, EE, LT, LV, MT, SK, SI, BG, IS, NO, TR, HR, RO, IT, HU
I2H(20) FR, IT, BE, NL, DK, IE, GB, GR, ES, PT, AT, FI, SE CZ, EE, HU, LV, LT, SK, SI, IS, NO, CH, TR,
BG, HR and RO.
Note: when injectors are changed, the new one should be marked by the gas technician
Injectors should always be changed by the authorized person.
Gas Type and working pressure:
I2H(20):G20 at 20 mbar.
I3B/P(30):G30,G31 or their mixtures at (28-30)mbar.
I3+(28-30/37):G30 at (28-30) mbar,G31 at 37mbar.
Important safety requirements
Location
The hobs may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom, shower room or garage.
Before making the cut out in the worktop ensure that there is a minimum distance of 55 mm between the rear edge of the
hobs and the wall. A minimum distance of 100 mm must be left between the side edges of the hobs and any adjacent
cabinets or walls. The minimum distance combustible material can be fitted above the hobs in line with the edges of the hobs
is 400 mm. If it is fitted below 400 mm a space of 50 mm must be allowed from the edges of the hobs. The minimum distance
combustible material can be fitted directly above the hobs is 700 mm. (see Figure 10)
Notice that a horizontal separation below the base of the hotplate is needed.
The minimum distance between this separation shall not exceed 150mm.

7
Figure 3
Warning: The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is
installed. Ensure that the kitchen is well ventilated especially when the appliance is in use. Keep natural ventilation
holes open or install a mechanical ventilation device.
Prolonged intensive use of the appliance may call for additional ventilation, for example opening of a window, or
more effective ventilation, for example increasing the level of mechanical ventilation where present.
Warming: The base of the appliance should be protected from contact by a horizontal partition or plate.
Installation
IMPORTANT: The gas cooker must be installed by a competent person to the relevant Gas Standards.
Please, ensure that, once the gas cooker is installed, it is easily accessible for the engineer in the event of a breakdown.
WHEN THE GAS COOKER IS FIRST INSTALLED
Once the gas cooker has been installed, it is important to remove any protective materials, which were put on in the factory.
Any gas installation must be carried out by a competent person.
Important: When installing the gas cooker above a built-in oven, the oven should be placed on two wooden strips; in the
case of a joining cabinet surface, remember to leave a space of at least 45 x 560 mm at the back.
When installing on a built-in oven without forced ventilation, ensure that there are air inlets and outlets for ventilating the
interior of the cabinet adequately.
Gas Connection
A: End of shaft with 1/2 BSP male thread
B: Washer Figure4

8
C: Connector nut
D:Barbconnectorforhose (SeeFigure11)
Cut Out dimensions
The dimensions of the cut-out are given in the diagram. (Dimensions are given in mm.)
Figure 5
Electrical connections
Any electrical work required to install this gas cooker should be carried out by a qualified electrician or competent person.
Check the last letter of your model to know the electrical supply type: A is for AC,D is for DC.
See PAGE 1 to check the electrical supply of your model
The GAS COOKER MUST BE EARTHED
If the hobs to be connected to a 110~240 V 50/60 Hz AC electrical supply.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the hobs rating label.
Ensure that the hobs supply cable does not come into contact with surfaces with temperatures higher than 50 deg. C.
Use with D.C battery
When your cooker is the one fitted with D.C supply device only, you are suggested to use one 1.5V battery.
Be sure that the battery is well fixed then you can follow the “Lighting” procedure.
Take off the battery if you won’t use the cooker for a long time. Check the working performance everytime before cooking.
824
474