
klokers.com
BATTERY•CHANGE
For any technical questions, contact us at:
e-mail : clientcare@klokers.com
It is essential to set the time by turning the discs counterclockwise.
This will ensure a good time setting and indexation of hours and minutes.
We remain at your disposal in case any problem persists after the battery change and time set.
Do not unscrew
Unscrew (1)
Lift (3)
BATTERY CHANGE INSTRUCTIONS
OPEN THE CASE BACK
1. Using a screwdriver, loosen the ve back screws (warning: do not unscrew the cross-headed screw)
2. Set screws aside
3. Lift case back using the casing notch (using the notch at 6 o’clock
and a piece of wood or plastic as a lever)
4. Remove the case back (do not disunite the whole as there are small springs inside)
5. Set the case back aside
6. Remove the battery
7. Test the removed battery and store it
8. Insert a new battery and check for correct contact ensuring that discs move
9. Replace the seal (ideally change it)
10. Move aside the red button in order to facilitate placement of the case back
CLOSE THE CASE BACK
11. Reposition the case back
12. Place and tighten the ve back screws crosswise
13. Check that the red button is working correctly
14. Set the discs by following the user manual.