www.KlusDesign.eu 6
3035-KOZE mounting instructions
c) Preparation of the 3035-O lighting xture
Bottom view
Top view
a. Drill holes for locking bolts in the
proled orientation line in the
3035-O prole (2).
The number of holes must be equal
to the number of bolts used. Each hole
should be in the middle of the
corresponding item (1.2). There must
be a minimum of two bolts
per 1 meter of a prole.
b. Drill a hole in the 3035-O prole (2)
for the cable gland.
NOTE! The 3035-O prole (2) must be
shortened by 6 mm / 0.24” at each end
where the end caps will be mounted.
Mount the power supply (7) on the back
of the prole in such a position that
it ts into the opening of the
RAM-3035-KOZE prole.
Run the power cable to the power
supply through one of the channels
in the 3035-O prole (2.1), so that it does
not protrude above the surface.
a. holes for locking bolts ø 2,5 mm / 0.1”
b. hole for a gland ø 6,5 mm / 0.26”
item (1.2)
Adhere the LED tapes (5), mount the
gland (6) and route the power cable
through it.
Attach end caps to the item 2. (8).
Locking bolts (3) can be tightened
preliminarily in the pre-drilled holes
before mounting the prole at its
destination (after mounting the LED
tapes).
Ic
IIc
IIIc
6.
1.2
2.
3.
8.
5.
8.
1.2
7.
2.
1.2
2.
1.2 1.2
7.
3.
3.
