Congratulations! You have acquired
perhaps the finest guitar speaker cabinet
available today. Each KW brand speaker cabinet
is handmade to the highest of exacting
standards. Only the highest quality wood and
materials are used in its construction. This short
informative manual will demonstrate how to get
the most out of your new cabinet as well as how
to care for it.
A speaker cabinet by design is a fairly
simple product. However, your KW Cab does
have many features that are not usually found on
just one cabinet. There are four main sections to
discuss. Firstly and most importantly is the
ELECTRONICS. Before we discuss the
connections please be aware that you should
only use specific high quality ¼” speaker cable
connections. The use of instrument level cables
can damage your cabinet and equipment. Also
always connect your speaker cabinet before
turning on your amplifiers power, failure to do
so could damage your amp. There is one ¼”
mono jack on KW 1x12 speaker cabinets. This is
typically 8 or 16 ohms, depending on your order.
You will notice that the wire inside the cabinet is
very high quality Audioquest© brand cable, for
the best signal transmission possible.
The second added feature of your KW ST-1
is the flexible removable back. This partially
removable back allows you to have the feel and
sound of an open back cabinet which is generally
more “airy” sounding and often more articulate.
The screws that retain the back accept either
square or Phillips head style screwdrivers.
When reattaching the back take care not to over
tighten the screws.
The third feature is the removable front
grill. KW Cabinets use a special light grade cloth
grill that is not only highly decorative but also
especially thin, which allows better sound flow
and less absorption. However, being this grill
cloth is light grade it is less durable, and care
need be taken, especially when removing the
grill. The grill is attached via Velcro tabs on its
back. It should only be removed if changing the