Knight Eko Workstation User manual

Tools Required:
Assembly Instructions
Powered screwdriver.
Eko Workstation

knightgroup.co.nz
Page 2
Assembly Instructions
· To prevent possible scratches or damage, assemble
the desk upside down on a soft surface such as a
blanket, carpet or packaging.
· Attach Leg to the top assembly by using bolts, spring
washer, flat washer. Tighten using the allen wrench.
Recommended
2-person Step
Eko Workstation

knightgroup.co.nz
Page 3
Assembly Instructions
Step 1
Step 2
Fit the pull bar to the top side of the mechanism according to the number corresponding to your
worksurface depth. This number will locate over of the raised cylinder
Insert dowel pins (d1) into panel D. Insert cam bolts (c1) and dowel pins (d1) into panels X, Z, Y1 &
Y2, then turn the panel Y around 180° and insert cam bolts (c1) into panel Y1.
Eko Workstation

knightgroup.co.nz
Page 4
Assembly Instructions
Fix cams on panel Y2 into cam bolts (c1) on panel Y1 and fully tighten.
Insert cam bolts (c1) into panel A1 and A2.
Step 3
Step 2
Eko Workstation

knightgroup.co.nz
Page 5
Assembly Instructions
Fix cams on panel D into cam bolts (c1) on panels X and Y1 and fully tighten.
Fix cams on panel D into cam bolts (c1) on panels Z and Y2 and fully tighten.
Step 5
Step 4
Eko Workstation

knightgroup.co.nz
Page 6
Assembly Instructions
Attach connectors (c3) to panels A1 & A2 with screws (s5) and fully tighten. Insert the connector
(c4) into panels A1 & A2 and fully tighten. Cover the cam covers (c2) on the top of the cams.
Connect panel D and panel X, Y, Z by using bracket (b1).
Step 6
Eko Workstation
Complete