Koala Kare KB100-ST User manual

KB100-ST and KB110-SSRE Baby Changing Station
Cambiador Plegable
Table à Langer
Babywickeltisch
Your unit can be installed to meet ADA regulations when and where applicable. Refer to
Federal Register, Volume 56, No 144 28 CFR Part 36.
You are responsible for the safe operation of this unit.
KOALA KARE PRODUCTS
Installation and Operation Instructions
Koala Kare Products ǁ6982 S Quentin St. ǁCentennial, CO 80112
IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG
DURCHLESEN.

Please Note:
To assure proper installation, it is suggested that a qualied person or carpenter install the Koala Baby
Changing Station. Koala Kare Products will not be responsible if the station is not installed properly.
Koala Baby Changing Stations have been tested to hold a substantial static load. The unit must be
attached to a permanent wall that is capable of holding a substantial load. The maximum recommended
total weight for this baby changing station (including baby and parcel bag) is 60 lbs. Excessive weight
may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child’s midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible “click”. Straps can be adjusted
to make strap tighter or looser as required.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly
–
Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to unit
at both ends.
– Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
– Provides a clean, convenient place for customers to attend to their children.
TOOLS NEEDED
Gloves Phillips Head
Screwdriver
Level Pencil
Drill 1/8” Drill Bit Measuring
Tape
Stud Finder
OPERATING INSTRUCTIONS
HARDWARE PROVIDED
Four ¼”x 3” Phillips Panhead Wood Screws Four ¾” x ¼” Flat Washers

Step 1.
Remove changing station from the shipping container and check for any freight damage.
Identify the best location for installing the unit. Hold the unit in place and open the bed.
Make sure you have taken the operating clearance into consideration.
Step 2.
Select the wall area where the unit will be
installed. Measure from the oor 46½” (1181
mm) on stud center and mark the wall. Hold the
unit in place to verify the alignment. Mark rough
opening 35½” W x 20½” H (902 mm x 521
mm) and cut a hole in the wall with a minimum
depth of 4¼” (108 mm) as measured from the
nished surface of the wall (ie: tile, drywall, etc).
Construct mounting frame as indicated in the
illustration. If the wall surface is masonry or
tile over wood studs, use caution when cutting
rough opening.
Step 3.
The unit will be mounted using four ¼” x 3”
wood screws through side holes as shown in
illustration.
Step 4.
Place the unit into the recessed area and use
the side mounting holes as a guide to drill a
pilot hole using a ⅛” drill bit. Insert the screws
and at washers through the side mounting
holes to hold the unit in place. It may be necessary to adjust the level of unit by using a
shim on the top right or left side of the unit before tightening securely to the studs.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built in
dispenser with sanitary bed liners. Replacement parts and additional liners can be
purchased from your local distributor
Horizontal Baby Changing Station Recessed Mounted
Model Numbers KB100-ST and KB110-SSRE
INSTALLATION INSTRUCTIONS

P/N 520
October 2012
WARNING: Never leave child
unattended.
WARNING: Avoid serious injury
from falling or sliding out. Always use
restraint system.
WARNING: Designed for Infants
Only. Age up to 3.5 years and weighing less
than 50 lbs. Keep one hand on the child at
all times.
Parcels or accessory items, or both, placed
on the unit may cause the unit to become
unstable.
ADVERTENCIA: No deje nunca
al niño desatendido.
ADVERTENCIA: Evite que el
niño se lesione por caerse o resbalarse
del cambiador Use siempre el sistema de
sujeción.
ADVERTENCIA: Diseñado
exclusivamente para bebés. Hasta 3 años
y medio de edad y con un peso inferior
a 50 libras (22,5 kg aproximadamente).
Mantenga siempre al niño sujeto con una
mano.
Colocar paquetes o accesorios, o ambas
cosas, encima del cambiador puede
provocar que se desestabilice.
ATTENTION : Ne laissez jamais
un enfant sans surveillance.
ATTENTION : Évitez les
blessures occasionnées par une chute ou
une glissade. Utilisez toujours le système de
retenue.
ATTENTION : Conçue
uniquement pour les jeunes enfants.
Jusqu’à 3 ans et demi et moins de 50 lb (23
kg). Conservez une main sur l’enfant à tout
moment.
Tout paquet ou accessoire placé sur la table
peut créer un déséquilibre.
WARNUNG: Das Kind niemals
unbeaufsichtigt lassen.
WARNUNG: Ernsthafte
Verletzungen durch Herausfallen oder
Herausrutschen verhindern. Immer das
Rückhaltesystem verwenden.
WARNUNG: Dieses Produkt ist
nur für Kleinkinder bis zu 3 1/2 Jahren und
einem Gewicht von höchstens 50 lbs. (23
kg) vorgesehen. Das Kind immer mit einer
Hand festhalten.
Durch Ablegen von Päckchen und Zubehör
auf der Wickeltisch kann diese instabil
werden.
ASTM F 2285-04 (2010)