Kodak Advantix 2100 Auto User manual

1
2100AUTO
Camera

2
Film Status Indicator (FSI)
A highlighted indicator advances from one symbol to another to
identify the status of the film inside the cassette.
Unexposed
Fully
Exposed
Partially
Exposed
4
3
2
1
Processed Negatives

3
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: Your model camera has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits provide
reasonable protection against interference in residential use. The camera generates,
uses and can radiate radio frequency energy and, if not used in accordance with the
instructions, may cause interference to radio communications. There is no guarantee
that interference will not occur. If this camera does cause interference to radio or
television reception, which can be determined by turning the camera off and on, you
may reduce the interference by the following:
— Reorient or relocate the receiving antenna.
— Increase the separation between the camera and the receiver.
— Consult the dealer or an experienced radio/television technician for help.
Changes or modifications not approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

4
Look for this logo to be certain the film
you buy is made for this camera.
Look for this logo to select a certified
photofinisher for developing your film and
to assure that you get all the features of
the Advanced Photo System.

5
+
OPEN
AUTO
(3) (4)(2) (5) (7)(6)
(9)
(10)
(1) (8)
(14)
(12)
(13)
(15) (16)
(17)
(19)
(20)
(21)
(18)
(22)
LCD
(11)

6
12
45
3

7
6
(a) (b) (c)
7
LCD

8
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.

9
ENGLISH
Welcome to the innovative world of the Advanced Photo System!
And thank you for buying this
KODAK ADVANTIX 2100 AUTO
Camera.
Need help with your camera or more information about the
new Advanced Photo System? Call Kodak (United States
only) toll free from 8:00 a.m. to 8:00 p.m. (Eastern time )
Monday through Friday at 1 [phone]. The toll free
number (in Canada only) from 8:30 a.m. to 5:00 p.m.
(Eastern time) Monday through Friday is 1 [phone];
please ask for ext. 36100.
9

10
CAMERA IDENTIFICATION
See inside cover flaps of manual for camera diagrams.
(1) Shutter Button
(2) Red-Eye-Reduction Button
(3) Rewind Button
(4) Self-Timer Button
(5) LCD Panel
(6) Viewfinder
(7) Self-Timer/Red-Eye-
Reduction Lamp
(8) Print-Size Selector
(9) Flash
(10) Lens-Cover Switch
(11) Lens
(12) Strap Post
(13) Film-Door Latch
(14) Meter-Cell Window
(15) Viewfinder Eyepiece
(16) Camera- /Flash-Ready Lamp
(17) Tripod Socket
(18) Battery Door
(19) Film Door
(20) Red-Eye-Reduction Indicator
(21) Battery Symbol
(22) Picture Counter

11
BATTERIES
This camera uses 2 AA-size alkaline batteries that supply power
for all camera operations. The camera automatically turns off after
approximately 3 minutes. You can resume power by pressing any one of
the function buttons.
Low-Batteries Warning
It's time to replace the batteries when —
• the Battery Symbol (21) appears on the LCD Panel (5)
• the film doesn't prewind, or
• the camera will not operate.

12
Battery Tips:
• Remember to keep spare batteries with you at all times.
• Read and follow all warnings and instructions supplied by the
battery manufacturer.
• Keep batteries away from children.
• Do not attempt to disassemble, recharge or short circuit the
batteries, or subject them to high temperature or fire.
• Store batteries in original packaging prior to use.

13
LOADING THE FILM
For excellent all-around results for indoor and outdoor picture-taking,
use KODAK ADVANTIX 200-Speed Film.
1. Turn the Film-Door Latch (13) to the "open" position and insert the film
cassette completely into the film chamber ➌.
2. Close the Film Door (19) .
3. Slide the Lens-Cover Switch (10) to the "open" position to uncover the
lens ➍and to start the auto-film prewind. (If the lens-cover is already
opened, press the shutter button to start the auto-film prewind.)
4. After the film prewinds, the Picture Counter (22) on the LCD Panel (5)
shows the number of exposures remaining (a).
NOTE: After you close the safety-interlock film door, you cannot
open the film door until the film is completely rewound into the film
cassette.

14
TAKING PICTURES
You can take Classic (C), HDTV (H), and Panoramic (P) pictures on the
same film cassette (see following table for typical print sizes). Your
photo-processing cost will be based on the format size(s) that you
use to expose the film.
1. Slide the Lens-Cover Switch (10) to uncover the Lens (11) and to turn
the camera on ➍.
2. Move the Print-Size Selector (8) to the desired format ➎.
3. Frame your subject inside the viewfinder marks within the
Viewfinder Eyepiece (15) for C, H and P formats. For a sharp
picture, stand at least 4 ft (1.2 m) from your subject.
4. Partially depress the Shutter Button (1) so that the Camera-/Flash-
Ready Lamp (16) glows green.
5. Press the shutter button completely down to take the picture ➏.

15
Typical Print Sizes (Formats)
C
Classic
31/2x 5" or 4 x 6"
(88.9 x 127 mm or
102 x 152 mm)
H
Group & Wide (HDTV)
31/2x 6" or 4 x 7"
(88.9 x 152 mm or
102 x 178 mm)
P
Panoramic
31/2x 10" to 4 x 111/2"
(88.9 x 254 mm to
102 x 292.7 mm)

16
Using the Self-Timer
1. Place the camera on a firm support.
2. Slide the Lens-Cover Switch (10) to uncover the Lens (11) and to
turn the camera on ➍.
3. Frame your subject in the Viewfinder Eyepiece (15).
4. Press the Self-Timer Button (4) and Shutter Button (1) at the same
time. The Self-Timer Lamp (7) "blinks" for 10 seconds before the
picture is taken.
NOTE: If you want to stop the self-timer operation before the picture is
taken, close the lens cover.

17
Tips for Better Pictures
• Hold the camera steady when taking pictures.
• Keep your pictures simple. Move close enough to your subject so it
fills the viewfinder but not closer than 4 ft (1.2 m).
• Take pictures at the subject's level. Kneel down to take pictures of
children and pets.
• Hold your camera vertically to capture tall, narrow subjects, such as a
waterfall, skyscraper, or single person.
• Add interest to your picture by framing it with a tree branch, window,
or even the rails of a fence.
• Keep the sun behind you for best subject illumination.

18
TAKING FLASH PICTURES
In dim light, such as indoors or outdoors in heavy shade or on dark
overcast days, you need flash. Your camera has a built-in flash which
automatically fires when needed. Wait for the Camera- /Flash-Ready
Lamp (16) to glow green, upon partially depressing the shutter button,
before you take the picture.
Flash-to-Subject Distance
ISO Film Speed Flash-to-Subject Distance
100 4 to 11 ft (1.2 to 3.3 m)
200 4 to 15 ft (1.2 to 4.6 m)
400 4 to 22 ft (1.2 to 6.6 m)

19
Flash Tips
• Turn on room lights and have the subject face the lights to minimize
red eyes in pictures.
• Stand at an angle to shiny surfaces like windows or mirrors to avoid
flash reflection and bright spots in your pictures.
• Keep your fingers and other objects away from the picture-taking lens,
flash, and meter-cell window to avoid dark or light pictures.

20
Using Red-Eye Reduction
This camera has an automatic flash that fires when you need it. To
minimize red eyes in flash pictures, use the red-eye-reduction feature.
1. Slide the Lens-Cover Switch (10) to uncover the Lens (11) and to turn
the camera on ➍.
2. Press the Red-Eye- Reduction Button (2). Make sure the Red-
Eye-Reduction Indicator (20) appears on the LCD Panel (5).
3. Have your subject look directly at the Red-Eye-Reduction
Lamp (7) located next to the lens.
4. Press the Shutter Button (1) to take the picture.
NOTE: To exit from the red-eye-reduction mode, repress the red-eye-
reduction button or turn the camera off by closing the lens cover.