Koelstra SITSET User manual

SITSET
RG20502201001
Gebrauchsanleitung (DE)
Brugsanvisning (DK)
Manual de utilización (ES)
Käyttöohje (FI)
Notice d’utilisation (FR)
Instruction manual (GB)
Istruzioni per l’uso (IT)
Gebruiksaanwijzing (NL)
Brukerveiledning (NO)
Manual de utilização (PT)

SITSET
PTNONLITGBFRFIESDKDE

3
SITSET
PTNONLITGBFRFIESDKDE
Deutsch DE 3 - 14
Dansk DK 3 - 14
Español ES 3 - 14
Suomi FI 3 - 14
Français FR 3 - 14
English GB 3 - 14
Italiano IT 3 - 14
Nederlands NL 3 - 14
Norsk NO3 - 14
Português PT 3 - 14

4
SITSET
PTNONLITGBFRFIESDKDE
Preface
Dear customer,
Please read this instruction manual carefully and study the appendix with the safety information and
warranty before using the bouncer. It is important that every person using this bouncer reads and
understands both documents. Demonstrate how the bouncer works, before lending it to anyone else. If
you do not follow the instructions, maintenance suggestions and warnings, you may be jeopardising your
child's safety. Keep both documents in a safe place for future reference. Safety instructions have the
symbol, tips the symbol.
The bouncer can be used for children aged 0 to approximately 9 months and has a load-bearing capacity
of 9 kg.
It is important to check the complete bouncer and all its components before use. If a part is missing or
damaged, please report this to your Koelstra point of sale within seven days of purchase.
We hope you enjoy using your Koelstra bouncer!
www.koelstra.com
This product has been manufactured in accordance with European standard EN 12790. This instruction manual
has been compiled with care and meets the requirements and regulations in accordance with the NEN 5509
standard.
Warning!
• Donotusethebouncerifyourchildcanalreadysitindependentlyorwhenyourchildbecomestoo
active.
• Usetheproductonlyforitsintendedpurpose.Usingitforanyotherpurposeisimproperanddangerous.
Koelstra BV cannot be held liable for any damage caused or injuries sustained due to incorrect or
improper use of your product.
• ThisKoelstraproductisnotatoy,neverallowchildrentoplaywithit.
Attention!
•A child's safety is your responsibility.
•The safety regulations and warranty conditions can be found in a separate, attached appendix. To
claim on the warranty, you must be able to show the bouncer together with the serial number*, proof of
purchase and a fully completed warranty form. The sticker with the serial number can be found on the
bottom of the bouncer.
Tip!
• Saveyourproofofpurchaseinthedesignatedplaceatthebackofthebookwiththesafetyregulations
and warranty conditions.
* Only so-called ‘hard goods’ have a serial number. ‘Soft goods’ do not have a serial number.

5
SITSET
PTNONLITGBFRFIESDKDE
Table of Contents
What's in the box? 6
Product Description 7
1 Unpacking and assembling 8
1.1 Before first use 8
1.2 Assembling 8
2 Use 9
2.1 Positioning/moving the product 9
2.2 Locking/unlocking the backrest 9
2.3 Adjusting the backrest 9
 2.4Usingthesafetybelt  9
 2.5Usingtherockingmode  10
3 Disassembling and storing the product 10
3.1 Disassembling and storing the product 10
3.2 Removing the upholstery from the frame 10
4 Maintenance 11
4.1 General 11
4.2 Cleaning the product 11
4.3 Washing in the washing machine 12
4.4 Faults 12
5 Accessories and parts 12
6 Technical specifications 13
7 Disposing of product and packaging 13

6
SITSET
PTNONLITGBFRFIESDKDE
What's in the box?
SITSET
Gebrauchsanleitung (DE)
Brugsanvisning (DK)
Käyttöohje (FIN)
Instruction manual (GB)
Manual de utilización (ES)
Notice d’utilisation (FR)
Manuale dell’utente (IT)
Manual de utilização (P)
Veiligheidsvoorschriften & garantievoorwaarden(DE)
Veiligheidsvoorschriften & garantievoorwaarden(DE)
Veiligheidsvoorschriften & garantievoorwaarden(DE)
Veiligheidsvoorschriften & garantievoorwaarden(DE)
Veiligheidsvoorschriften & garantievoorwaarden(DE)
Veiligheidsvoorschriften & garantievoorwaarden(DE)
Veiligheidsvoorschriften & garantievoorwaarden(DE)
Veiligheidsvoorschriften & garantievoorwaarden(DE)
Bouncer Supporting
frame
Instructions for use Safety regulations
Warranty conditions

7
SITSET
PTNONLITGBFRFIESDKDE
Upholstery
Adjustment catch
Backrest adjustment knob
Brake lug
Rocker brake
Supporting frame
Product description
Backrest locking knob
Sliding buckle
Safety belt
Locking detent
Reinforcement strap
Metal buckle
Strap with press-stud

8
SITSET
PTNONLITGBFRFIESDKDE
1 Unpacking and assembling the
product
1.1 Before first use
Danger, risk of death!
• Keep plastic packaging materials away from
children as they can present a choking hazard
for children.
• Beware of small parts. Your child may swallow
a small part and choke.
• Do not place any loose objects in the bouncer.
Warning!
• Beforeuse,checkyourproductforanydamage,
loose or missing parts, sharp edges and/or
protruding parts.
• Neverexceedthemaximumallowedweightin
the bouncer (see p. 13‘Technical specifications’.
Caution!
• To prevent damage, do not remove logos or
stickers. Some logos and stickers are required by
law.
Tip
• Forenvironmentalreasonswerecommendthat
you dispose of the packaging at your local civic
amenity site.
The bouncer is packed away
1. Take the bouncer out of the box.
2. Remove all packaging materials and discard
immediately.
3. Use the product description to check if the
bouncer is complete (see p. 7).
1.2 Assembling
Warning!
• Beware of any moving parts or hinges when
unfolding or folding the bouncer. Beware of
getting your fingers or hands, or your child's
fingers or hands trapped.
Caution!
• Toavoidthedangerofngersbecomingtrapped
and sudden unwanted adjustments, check that
the locking knob has been securely engaged
each time before use.
• Check that the Velcro and press-studs are
properly closed and/or attached.
The supporting frame has separated from the
bouncer.
1. Put the bouncer down with the seat flat on the
surface (see fig. 1).
2. Turn the two legs outward as far as they can go
(see fig. 2).
3. Connect the ends of the supporting frame to the
bouncer legs until you hear a click (see fig. 3).
Attention! Do not fit the supporting frame the
wrong way round. See fig. 8 for an illustration of
the right procedure.
4. Check that both locking detents are fully visible
(see fig. 4).
5. Place the bouncer upright.
4
2
1
3

9
SITSET
PTNONLITGBFRFIESDKDE
2 Use
2.1 Positioning/moving the product
Danger, risk of death!
•Never place the bouncer near heaters, open
fire or other sources of heat as this could pose
a fire hazard.
•Never place the bouncer on a platform such as
a table or sofa.
•Keep the bouncer away from loose leads, wires
on account of the risks of falling objects,
strangulation or choking.
Warning!
• Nevercarrymorethanonechildinthebouncer,
the maximum load is 9 kg.
• Never leave your child in the bouncer
unsupervised.
• Neverplacethebounceronaslipperysurface,to
prevent the bouncer from sliding away.
• Placethebounceronalevel,stableandrough
surface.
• Neverliftormovethebouncerwithyourchild
sitting or lying in it.
• Removeallobjectsaroundthebouncerthatmay
be within your child's reach and that may cause
a dangerous situation (such as white spirit or
matches).
• Alwaysplacethebouncerintheshadeoutdoors.
Protect your child's sensitive skin from UV
radiation in the shade too. For example, you
could use sun tan lotion or protective clothing.
• Aluminium, metal and synthetic parts can
become very hot in the sun. Make sure your child
cannot burn itself on any hot parts.
Caution!
• Never apply force if you experience resistance
when using the bouncer.
• Neverplacethebouncerinthesunforprolonged
periods of time. The upholstery can discolour
and plastic parts can be damaged.
Koelstra upholstery is of the highest UV protection
category.
• Transportthebouncerwithcare.Theframeand
the upholstery can be damaged if you bump or
scrape it.
• Never expose the bouncer to extreme
temperatures.
2.2 Locking/unlocking the backrest
To lock the backrest:
1. Put the bouncer down in front of you, with the
seat facing you.
2. Turn the locking knob towards you (see fig. 5).
The backrest is now locked and cannot be adjusted.
To unlock the backrest:
1. Put the bouncer down in front of you, with the
seat facing you.
2. Turn the locking knob away from you (see fig. 6).
The backrest is now unlocked and can be adjusted
using the adjustment knob.
2.3 Adjusting the backrest (see fig. 7)
Attention!
• Never adjust the backrest when your child is
lying in the bouncer.
1. Put the bouncer down in front of you, with the
seat facing you.
2. Check that the locking knob is unlocked (towards
you).
3.Using your right-hand thumb, press down the
adjustment catch on the adjustment knob.
4.Using your right-hand index nger, pull the
adjustment knob towards you.
5. Push back the backrest.
6. Pull the backrest upwards and secure it into the
desired position.
The backrest has 3 positions, one for sitting, one for
relaxing and one for lying (see fig. 8).
2.4 Using the safety belt
Caution!
• Only use the safety belt supplied with the
bouncer.
• Alwaysstrapinyourchildwiththesafetybelt.
8
5
6
7

10
SITSET
PTNONLITGBFRFIESDKDE
Attention!
• Always adjust the length of the safety belt
according to your child's size. Do this using the
sliding buckles on the safety belt.
• Make surethestrapsof the safetybeltarenot
twisted.
To lock the safety belt:
The buckle on the safety belt is unclasped.
1. Place your child in the bouncer.
2. Place one of your child's legs on each side of the
crotch strap.
3. Buckle the safety belt
(see fig. 9) .
4. Check that the safety belt is secure by giving it a
gentle tug.
5. Tighten the safety belt using the sliding buckle
on the strap.
To unlock the safety belt:
• Useonehandtopressdownbothplasticclipsof
the safety belt to unbuckle it (see fig. 10).
2.5 Using the rocking mode
To place the bouncer in rocking mode:
• Turntherockingbrakeonitsaxisuntilthebrake
comes to rest on both brake lugs (see fig. 11).
The bouncer is now in rocking mode.
To place the bouncer in stable mode:
1. Turn the rocking brake on its axis until the brake
comes to rest on the floor.
2. Raise the bouncer slightly at the rear and turn the
rocking brake as far as it can go (see fig. 12).
3. Put the bouncer down again.
The bouncer is now in stable mode.
3 Disassembling and storing the
product
3.1 Disassembling and storing the product
Caution!
• Toavoidanydamage,donotplaceanyobjects
on or against the folded product.
Attention!
• Always store folded products away from
children.
The bouncer is assembled.
1. Put the bouncer down with the seat flat on the
surface (see fig. 3).
2. Using your thumbs, press down both locking
detents on the supporting frame (see fig. 13).
3. Pull the supporting frame away from the legs of
the bouncer.
4. Fold the legs inwards until they lie flat on the
bouncer (see fig. 1).
5. Store the supporting frame and the folded
bouncer together.
3.2 Removing the upholstery from the frame
A. To remove the safety belt:
1. Feed the strap at the rear of the bouncer through
the groove of the metal buckle as shown in
figure 14.
2. Pull the strap at the front of the bouncer through
the grooves in the seat.
3. Put the safety belt away.
B. To remove the upholstery from the frame:
1. Pull the press-studs from the plastic part of the
frame (see fig. 15).
2. Turn the bouncer upside down.
3. Put the bouncer down with the seat flat on the
surface (see fig. 3).
3. Disconnect the straps that surround the frame at
the bottom (see fig. 16).
4. Disconnect the Velcro tape on the bottom of the
upholstery.
9
10
12
13
11