1 Unpacking and assembling the
product
1.1 Before using it for the first time
Danger, risk of serious injury or death!
• Keep plastic packaging materials away from
children as they can present a choking hazard
for children.
• Bewareofsmallparts.Yourchildmayswallow
a small part and choke.
• Removeallobjectsfromthetravelcot(suchas
pillows and soft toys) which could cause
strangulation or choking hazards.
Warning!
• Beforeuse,checkyourproductforanydamage,
loose or missing parts, sharp edges and/or
protruding parts.
• Neverexceedthemaximumallowedweightfor
the travel cot (see p. 13 ‘technical specifications’).
Caution!
•To prevent damage to the travel cot, do not
remove logos or stickers. Some logos and stickers
are required by law.
Tip
•For environmental reasons we recommend that
you discard the packaging at your local civic
amenity site.
The travel cot is packed away
1. Remove the folded travel cot that is packed in
the travel bag, from the box.
2. Remove all packaging materials and discard
immediately.
3. Usetheproductdescriptiontocheckifthetravel
cot is complete (see p. 7).
1.2 Unfolding the travel cot
Warning!
•Beware of any moving parts or hinges when
unfolding, folding or adjusting the travel cot. Beware
of getting your fingers or hands, or your child's
fingers or hands jammed.
Caution!
• Toavoiddangerofngersbecomingjammedor
the travel cot suddenly folding, check that all the
locks are securely engaged each time before use.
• Checkeachtimebeforeusewhetherallthecorner
pieces and locks are covered by the cover flaps.
• Checkthatthezipsandpress-studsareproperly
closed and/or attached.
The travel cot is folded.
Untiethemattressfromthepackage:
1. Remove the travel cot from the travel bag.
2. Laydownthepackageinahorizontalposition.
3. Open the three Velcro mattress (see fig. 1).
4. Lay the mattress aside for now.
Assemblingthetravelcot:
Caution!
•When assembling the travel cot it is very
important that you first set up all the edges and
only then push the central lock towards the floor.
If you do not adhere to the sequence below,
you may (permanently) damage the product.
A. Set up the edges of the cot
1. Position the folded package in a vertical position
(see fig. 2).
2. Gently separate the four legs slightly (see fig. 3).
3. Pull one edge of the cot upwards to form a
straighthorizontalline(thesideofthetravelcot
is now taut, see fig. 4).
4. Rotate the frame lock on the edge of the travel cot
180 degrees around its axis towards the inside of
the travel cot so it can be locked (see fig. 5).
Attention: The frame lock must be rotated at an
angle of 180 degrees, otherwise the lock is not
correctly secured and the travel cot may
suddenly fold.
5. Repeat the two above steps until all four edges
of the travel cot have been secured.
6. Fold the four cover flaps over the frame locks and
attach the Velcro (see fig. 6).
7. Fold the four corner cover flaps over the corner
pieces and attach the Velcro and fasten the
press-studs (see fig. 7).
1
3
2
4 5
6 7
