Kogan 4K GALAXY User manual

WIDE ANGLE 4K GALAXY
DRONE
KA4KGLXDRNA

• Read these instructions thoroughly before use.
• Do not discard of these instructions.
• Improper operation may cause serious personal injury or property damage.
• The product is not suitable for children below 14 years of age. It is not a toy.
• Ensure the device is operated with care at all times and used only as directed in
these instructions.
• The flight site must be a legal remote control model flight site. Check the rules and
regulations for your local area before operating this device.
• Do not operate near crowds of people.
• Assess all potential obstacles prior to operation. This includes, but is not limited to,
high-rise buildings, power lines, traffic, etc.
• Do not operate in extreme heat or cold weather. Suited only for use in 0° - 40° C
temperatures.
• Do not use during high wind or rain. Check weather conditions prior to operation.
• Do not operate around bodies of water (lakes, creeks, etc) or damp ground. Water
damage to the device may cause component failure, resulting in safety risk. Keep
the device dry at all times.
• Do not touch the high-speed rotating parts (propellers) while in use.
• Do not operate the device if it is damaged. In the event of damage, discontinue use
immediately and contact help.Kogan.com for assistance.
Battery Safety
This device contains a Lithium Polymer (Li-Po) battery. As such, extra care should be taken
to avoid risk of property damage or personal injury.
• Do not operate while charging battery.
• Remove battery when not using for long periods of time.
• Do not leave battery in device when fully charged or above 50%.
If disposing of this product, take care to dispose of the battery correctly. Do not
throw battery in general waste. Please take the device to a recycling center and
ensure the battery is recycled separately. For further information, please contact
your local council office or waste disposal service.
SAFETY & WARNINGS

OVERVIEW

Remote Battery Installation
Insert x3 AA batteries, paying careful attention to the polarity symbols (+ / -).
Note: When the controller battery is low, the controller will emit a ‘beep-beep’ sound with
flashing light. Ensure to land the drone safely and replace the batteries.
Drone Battery
1. Connect the USB cable to a USB outlet:
To c h a r g e t h e d ev i c e , c o n n e c t t h e b a t t e r y p l u g t o
the USB charging cable, and insert it into a
computer or compatible USB adapter. The RED
indicator light will turn OFF during charging and
will turn ON once battery has fully charged. Do
not leave the battery on charge once fully
charged.
• Charging time is 100-120mins.
• Flight time on a full charge is
approximately 6.5mins.
2. Connecting the drone power supply:
Put the charged battery into the battery holder on the drone and then place the
battery plug into the drone’s power supply. Once connected, the drone lights will
turn ON.
INSTALLATION
Switch

Drone
1. Folding function:
To fold the drone, please first fold the back arms and then fold the front arms. To
unfold do the same process in reverse order.
2. Drone fan installation:
The ‘A’ arms should be installed to the upper left and the lower right corners of the
drone. The ‘B’ arms should be mounted to the upper right and the lower left corners
of the drone.
At the corner of each arm, install the propellers.
3. Drone protection rack installation:
Position the protective frame at the drone’s arm and install fastening, as per below
image. Repeat these steps for all four arms.
Note:The drone will not lift off if the protective frames are not securely attached.
Ensure they are tightly installed before operating the device.

1. Install app on Your M obi le Ph one:
Please scan the below QR code to download the app according to your phone’s system.
2. Connect Devices:
• Enter the Settings, open the Wi-Fi option and find the device Wi-Fi hotspot name
“KY/HD/Du/******” and connect.
• After successful connection, return to the desktop, open the downloaded app and
enter the program.
3. First Interface:
1) Start
2) FAQ
3) Settings
Note:
Only one phone at a time is able to connect to the drone.
APP INSTALLATION
iOS
Android
1
2
3

4. Home Screen:
Functions:
1
Back
10
Fixing mode
2
Photo
11
Headless mode
3
Music
12
Gravity induction
4
Video
13
Gesture mode
5
Image flip
14
Control panel
6
Media library
15
Settings
7
Split screen mode
16
Effect filters
8
Speed (30%, 60%, 100%)
17
Manual focus
9
Gyroscope correction
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17

5. Gesture Mode
Click gesture button, the system will automatically recognise different gesture to take pics or
videos. Gesture as below:
Photo: From approximately 2m into front of the camera, hold one hand away from your
body with your palm facing the camera. After the camera recognises the gesture, it will start
a 3 second countdown and take a photo (your hand can be lowered at this point).
Video:From approximately 2m into front of the camera, hold one hand away from your
body with a closed fist facing the camera. After the camera recognises the gesture, it will
start a 3 second countdown and begin recording (your hand can be lowered at this point).
6. Music
Click music button to enter the music library and select background music.
7. Manual Focus
Press and hold the manual focus button and slide to adjust (1 – 50x digital magnification).
8. Effect Filters
• Press the filter effects button to enter the effects control menu.
• Click the effects button again to display the various filter options.
• After selecting the desired filter, click the effects button to exit the filter options.
• Click the “ ” button to exit to the home screen.
Notes:
• Not all models support this gesture mode.
• The time between gestures should be at least 3 seconds.
• Recording can only be stopped by pressing the “Stop” button.

Remote Control
1. Mobile phone grip:
Pull out the remote-control lower grip, clamp the phone securely in place.
2. 2.4G frequency:
Tu r n o n t h e r e m ot e c o n t r o l , p u s h t h e t h r o t t l e joystick to the highest and then pull to the
lowest. You will hear a “tick” sound. The drone indicator light is on, match the right
frequency to complete (2.4G frequency), then you can take off.
If unable to take off, ensure that the installation and assembly steps have been
completed as specified in this guide. Check that the protective frame is tightly secured to
each arm.
3. One key take off and one key landing:
This feature is determined by the barometer and a variety of other environmental factors.
The drone will automatically go into one key landing when flying if the battery gets low.
Changes to the drone’s flying height are normal.
Note: For one key take off and one key landing to work, ensure no other button is
pressed at the same time.
OPERATION
One key take off
One key landing

4. Flight control:
Throttle (left lever)
Push the left lever
upwards
The drone rises
Push the left lever
down
The drone descends
Forward and backward (right lever) (with camera front side)
Push the right lever
upwards
The drone will move
forward
Push the right lever
down
The drone will move
backwards
Left and right-side fly
Push the right lever
to the left
The done will fly to
the left
Push the right lever
to the right
The done will fly to
the right
Tu r n l e f t a n d r i g h t ( w i t h camera front side)
Tu r n t h e l e f t l e ve r t o t h e
left
Drone will rotate left
Tu r n t h e l e f t l e ve r t o t h e
right
Drone will rotate
right

5. Fine-tuning controls (with camera front side):
Use the fine-tuning controls if drone begins moving in one direction without any
user input.
Forward and backward fine tuning
Note:
Calibration of the drone is required every time it is turned ON or if the
environment/location changes. Without calibration the drone may not operate
as intended even without input from the user.
Partial rear
Partial front

Rotating fine tuning
Tu r n L e f t
Tu r n R i g h t

Headless mode
When switching to headless mode, the drone will override
its front and rear azimuths and reposition the front and rear
using the remote control as a reference point. Such as:
when the right lever is pushed forward, the drone will fly
away from the remote control; when the right lever to pull
back, the drone will fly towards the remote control (camera
front side).
1. The drone must be positioned with the camera facing you and the remote control
directly in-line with the drone. Short press the top left button and you will activate
headless mode.
2. When headless mode is active of the remote control will sound “Di Di Di...” and the
drone lights will. Short pressing the top left button again will deactivate headless
mode and the remote control will play a "flute" sound.
One key return
Press and hold the top left button to activate one key
return feature. The drone will override the current front
and rear left and right directions, automatically defined
by the headless mode and move towards the remote
control. To u c h i n g t h e right lever will stop this function.
Speed selection
Short press the top right button to cycle through the drone
speeds;
• Slow - drone plays "flute" sound
• Medium - drone plays "flute" sound twice
• Fast - drone plays "flute" sound twice
(Recommended beginners start with slow speed).
front
Head forward

Reset settings
1. To r e s e t t h e d r o n e , push the sticks (Figure 1), 2 seconds after the remote control will
plays “flute” sound. The drone’s lights will quickly flash a few times if the reset was
successful.
Emergency landing
1. During the operation of the drone, if need to urgently stop. Press and hold the top
left button. The drone will stop flying and land. (Please do not attempt this
operation while flying at high altitudes)
2. When the drone leans over 45 degrees, it will stop for protect the engines.
3. When using the app controls the drone, slide the throttle down and press the one
key take off button, it will perform an emergency landing.
Note: If the drone crashes, these is a high possibility that it has lost connection with the
app. Check the Wi-Fi connection status and reconnect if required.
Figure 1

Problem
Cause / Issue
Solution
The drone batteries are
inserted and the five
indicator lights are
flickering.
Remote control and drone
connection are not successful
Please re-perform the remote
control and the flying drone
connection
The drone batteries are
inserted and the five
indicator lights stop
flickering. The drone has
no response.
Check if the remote control and
the flying drone are powered
on.
Check whether the remote
control and the drone battery
are in a low power state.
Is the battery positive and
negative terminal or placed
correspondingly.
Tu r n o n t h e r e m ot e c o n t r o l
and insert the drone battery.
Use full charged battery.
Reinsert the battery and
confirm that the battery
positive and negative pole
piece of contact is normal.
When the throttle lever
is used, the motor does
not turn and the drone
does not fly. The
indicator light on the
disc starts flashing.
Lithium battery power
shortage.
Charge the battery or replace
with another fully charged
battery.
The drone main rotor
continues to run but
cannot take off.
The main rotor deformation.
Drone battery power shortage.
Replace the main rotor.
Charge or replace the battery
with another battery.
The drone is not level.
The main rotor deformation.
Replace the main rotor.
The flying drone will still
go on or on after
moving.
The gyroscope is not at all right
Drone engine malfunctioned.
The remote control can be
automatically corrected or
restart the re-frequency.
Ensure that the drone is placed
on a flat ground surface before
take-off. Do not launch the
drone from an incline or from
hand.
The drone was not
stable and fell.
Drone will not take off.
Protective frame is not secured
tightly.
Re-perform assembly and
installation steps, ensuring
protective frame is secured.
TROUBLESHOOTING

NOTES

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com