L.L.Bean All-Weather Presidential Rocker User manual

02/15/2019 www.llbean.com
Assembly Instructions
www.llbean.com
Product Support 1 800 341 4341
Care
All-Weather
Presidential Rocker
This material is made of HDPE plastic
resin that has been purified and UV
protected. It is generally cared for and
cleaned with soap and warm water. For
certain stains and additional cleaning
power, a 1/3 bleach and 2/3 water
solution can be used on the product
without aecting the color. Also, a
popular method of cleaning is a high-
pressure power wash. (Not to exceed
1,500 psi, which is the equivalent of a
car wash.) The surface characteristics
of the product may require the use of a
soft bristle brush to get into the creases.
The hardware used in the assembly
and construction of our furniture is
18-8 stainless steel with an AlloChrome
3200+™ finish and a cosmetic coating,
providing a high level of corrosive
resistance.
A practical solution to signs of corrosion
is to wash the product with soap and
water, using a soft bristle brush to scrub
the corroding areas of the hardware.
Also, use appliance touch up paint in
the appropriate color to protect the
hardware. Appliance touch up paint can
be purchased at local hardware stores.

1 2 3
4
Front of Seat
is Wider
Place Seat Panel, Back Panel, and Head Piece in
position. Start 4 screws, but KEEP LOOSE.
B
Attach Finials to tops of posts. Perform one last
check to make sure all screws are tight.
Make sure all
screws are tight
5 6
PARTS TOOLS
x 14
x 4
x 2
4mm T-handle
hex key (included)
4mm hex, straight,
for drill (included)
Thank you for purchasing our All-Weather
Presidential Rocker.
Assembly of this product requires a 4mm Hex Key
which is included. Additionally, a 4mm Straight Hex
bit is included for use with a hand-held power drill.
We have found it helpful to have a second person
present in at least one step of the assembly.
Position other Side Frame onto Braces and Seat
Frame. Start five (5) screws, but KEEP LOOSE.
A
Long
Braces
Front of Seat
is Wider
Attach Long Braces, Short Brace and Seat
Frame to Side Frame using five (5) screws.
A
Completely push screws through
rocker bottoms.
Flex of rocker bottoms may be required
to line up screws with pilot holes.