L.L.Bean HOME 9’ Aluminum Collar Tilt Umbrella User manual

9’ Aluminum Collar Tilt Umbrella
Thank you for purchasing our Collar Tilt Umbrella. Assembly of this product requires no tools.
We have found it helpful to have a second person present during the assembly process.
1 of 3 0DTP1/0DTP9062410

STEP 1
Read through these instructions thoroughly before
beginning assembly. We have found this to be of
great value when first assembling this product.
STEP 2
Remove all parts from packing material. Aluminum
pieces should be placed on a non-abrasive surface
(like the carton or carpet) to prevent damage to the
finish.
PARTS
ASSEMBLY:
Assembly of this product requires no tools. We have
found it helpful to have a second person present
during the assembly process.
Your new market umbrella has a simple 2 piece
connector. Lay both ends of the Collar tilt umbrella
on the ground. You will find one end with a hole and
the other end with a retractable button. Align hole
with button and gently slide the two poles together.
Push till button pops through the hole. Do not use
excessive force putting the poles together.
Screw the finial on to the top of umbrella.
A crank handle turns to lower and raise the canopy.
Twist the collar in the middle of the pole left or right
to tilt your canopy.
It is recommended that the umbrella canopy always
be kept in the closed position when not in use. Use
with table; large weighted umbrella stand is
recommended
WARNING
· Put canopy in closed/down position in inclement
weather.
· Store umbrella indoors in severe
weather and windy conditions.
· Always use base with umbrella as
recommended by the manufacturer and
weighted properly for the size of your umbrella.
· Injury from impact with a fly-away
umbrella could result upon failure to follow instruction
s
www.llbean.com
Product Support 1 800 341 4341
Crank to open
Twist to tilt
2 of 3 0DTP1/0DTP9062410