Leap Desk Converter User manual
Installation Instructions
LEAP
Desk Converter
Please read these instructions carefully before assembling and using the
equipment. Improper installation or use may result in injury or damage.
• If a problem occurs during installation, please contact your local qualied tter.
• If the accessories are damaged or lost, please report to your supplier.
• Check all cables before use in the event of distortion.
• The factory is not responsible for any damage to the desktop caused by over-
loading.
• The factory doesn’t take any legal responsibility for product damage caused
by self-building, improper installation, over-loading, improper use or day to day
wear.
• Please don’t use this item for anything other than its designated purpose.
WARNING
1
1 2
PARTS LIST
3
INSTALLATION STEPS
STEP 1
Connect base and column with 4 screws(M6*14),
then plug the control box cord into column
connector.
STEP 2
Connect base support block and column with
4 sunk screws(M6*8).
3 4
STEP 3
Plug the controller into the control box and
raise the shelf a small bit. Install the table top
with 4 sunk screws (M6*25).
STEP 4
Install monitor bracket support with 4
sunk screws (M6*12).
STEP 5
Set-Up of desk converter is complete
5
5 6
BUTTON INSTRUCTION
Combination Button
Press “M” button rst, then press “1” or “2” to memorise the current height.
TROUBLE SHOOTING
7
LED ashing ‘RST’ – System should be reset
1. Ensure all the power cords, connecting cables and handset cord are connected
correctly
2. Press ‘V’, the actuators will move down to the lowest position
3. Press ‘V’ again and hold until ‘RST’ flashes on the LED
4. Press ‘V’ again – the actuators will go down by roughly 7mm, and go back up
5. Your reset is now complete, and your convertor is ready to use
7 8
LED displays E01 - Overcurrent protection.
Operation:
1. Press any button, LED will display “RST”.
2. Reset.
LED displays E07 - Abnormal Height Limit.
Operation:
1. Press any button, LED will display “RST”.
2. Reset.
LED displays H01 - Overheating/Work protection.
Operation:
Rest for 18 minutes rst, and then operate. (In
case of an emergency, power off the desk
converter and then power on again. Product will
now work as normal)
Table of contents
