slave: receive DMX signal
from host or controller
Host: AUTO running &send
DMX signal to slave
Please turn on lamp at first,
then to check effect &enter
in AUTO
Please press enter to edit
ADD.
Exchange XY CH（pan/tilt
fine）
using edition to test
&automatically correct the
position
Keep the original state
continues to run
motor reset, stop running
after 30 seconds turn off
back light
Motor reset, do not turn on
lamp(using menu or
controller to turn on lamp)
please press enter 2 times
Control by manual
please press enter 2 times to rest
all motors
Please press enter to edit.
Safety instruction
Important: Damages caused by disregard of this user
manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems.
Unpack and check carefully that there is no transportation
damage before using the unit.
The unit is for indoor use only. Use only in a dry location.
Do install and operate by qualified operator.
Do not allow childern to operate the fixture.
Use safety chain when fixing the unit. Handle the unit by
carrying its base instead of head only.
The unit must be intalled in a location with adequate
ventilation, at least 50cm from adjacent surfaces.
Be sure than no ventilation slots are blocke; otherwise the unit
will be overheated.
Before operationg, ensure that the voltage and frequency of
power supply matches the power requirements of the unit.
It’s important to ground the yellow/ green conductor to earth
in order to avoid electric shock.
Maximum ambient temperature TA: 40C. Don’t operate it
when the temperature is higher.
Don’t connect the device to any dimmer pack.
During initial start-up some smoke or smell may arise. This is a
normal proecess and does not necessarily mean that the
device is defective, and it will decrease gradually within 15
minutes.
Make sure there are no flammable materials close to the unit
while operating to avoid fire hazzard.
Examine the power wires carefully; replace them immediately
if there are is any damage.
Unit’s surface themperature may reach up to 85°C. Don’t touch
the housing bare-handed.
Installation
Bolt each clamp (1) to the omega holder with screw and lock
nut through the hole in the holder.
Fasten the omega holders (2) on the bottom of the base by
inserting quick-lock fasteners (3) into the holes of the base and
tighten fully clockwise.
Hang the fixture to the support (4) through clamp and fasten
the screws (5). Fasten the safety cable (6) through the bottom
of the base and over the support.
