LedGlow LU-RMT02 User manual

Instruction
Model：LU-RMT02, LU-RM03 （Only different silk-screen)
Specification：
1. IC model：HS1527
2. Working voltage：9V
3. Wordking current：5~5.5mA(±0.5mA)
4. Emission frequency：315MHz(±100K)
5. Emission power：≥10MW
6. Modulation system：ASK
7. Transmission distance：20-50meter
8. Quiescent current：≤3uA
9. Oscillation resistance：270K
This remote control is used in the lamp control above, the customer can
choose the mode at will.
1 key: Power on/off
2 key: Mode key
3 key: Color key
4 key: Speed key

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
The device has been evaluated to meet general RF exposure requirement.