LeetDesk PC Holder User manual

LeetDesk
PC Holder
Assembly Instruction

Attach the bottom plate (1) to either side bracket (2).
Do so by going in this order from top to bottom as seen in the
picture:
Nut
Flat Washer
Bottom plate
Side Bracket
Screw
2
1

Tighten the screws by holding the nut in place with the
included wrench while simultaneously using the included allen
wrench to turn it.
Do not tighten the screws too much, leave some space so you
can still freely move the bottom plate.
Attach the other side bracket using the same method as
before, again not tightening the screws too much.

Your PC Holder is now width-adjustable for the time being.
Adjust the PC Holder to the size of your PC by placing it inside
the PC Holder and adjusting the width by sliding the two side
brackets.
In it’s widest setting, the PC Holder can fit a 25cm wide PC.
Make sure to leave a little space to each side bracket when
your space is inside, as to not damage your PC when putting it
into the PC Holder.
After finding the right width of your PC Holder, you can fully
tighten the screws.

Afterwards use the included 12 included wood screws to fix
your PC Holder to the tabletop. Note that there are no
predrilled holes in the tabletop for the PC Holder.
This way you can choose which side of your LeetDesk you
want your PC Holder to be.

Please make sure, that the side bracket is at least 3-4 cm
away from the table leg as to not damage your PC Holder or
your Desk.
After you have attached the PC Holder to the tabletop slide
your PC inside it, making sure the screws are fixed tightly
beforehand.