Lefroy Brooks K1-1400 User manual

INSTALLATION INSTRUCTIONS
K1-1400
CROSS HANDLE 3-HOLE WALL BASIN MIXER TRIM ONLY,
TO SUIT R1-4015 ROUGH
K1-1401
LEVER 3-HOLE WALL BASIN MIXER TRIM ONLY,
TO SUIT R1-4016 ROUGH
K1-1401
K1-1400

2
Dimensions in Inches (& Millimetres)
Whilst every effort is made to ensure accuracy, design and dimensions are subject to
change without notice as part of the company’s product development process.
K1-1400
K1-1401
(203mm)
8''
Ø7/8"
(Ø22mm)
3-Ø 2"
(3-Ø50mm)
1 15/16∼2 7/16"
(49∼65mm)
(29mm)
1 1/8"
(194mm)
7 5/8"
(205mm)
8 1/16"
(54mm)
2 1/8"
(85mm)
3 3/8"
8"
(203.2mm)
3-Ø "
(3-Ø50mm)
2
1 15/16∼
(49∼65mm)
2 7/16"
(29mm)
1 1/8"
2 1/8"
(54mm)
(194mm)
7 5/8"
Ø "
(Ø22mm)
7/8
(205mm)
8 1/16"
(75mm)
2 15/16"

3
Please note:
When there is a difference in water pressure between
hot and cold supplies to the mixing valve, the pressures
should by equalized by a plumber in accordance with
best practice and legislation.
What you need to know
Prior to beginning installation. turn off the cold and
hot water lines and open the old faucet to release
built-up pressure.
Overtightening nuts may cause damage.
Wrap all threaded connections with pipe tape
available at your local plumbing supply store.
Always wrap in a clockwise direction. The fittings
should be installed by a state-licenced plumber.
Adjustable Wrench
Groove Joint Pliers
Hacksaw
Phillips Screwdriver
Pipe Tape
Spatula
Spirit Level
Your new bathroom faucet is designed for years
of trouble-free performance.
Keep it looking new by cleaning it periodically with
a soft cloth. Avoid abrasive cleaners, wire wool and
harsh chemicals as these will dull the finish and
void your warranty.
If you are soldering during faucet installation,
remove cartridges, seats, gaskets and washers
prior to applying flame, otherwise you will void
the warranty.
Cover drain openings to avoid losing small parts.
When cutting or soldering pipe, use safety glasses
to protect your eyes.
Correct installation may vary depending on previous faucet installation. All necessary supplies required for
faucet installation are not included, but may be found where plumbing supplies are sold. It is suggested that
IAPMO and/or CSA approved plumbing supplies are used during installation.
Tools: Maintenance
Safety Tips
Things You May Need
Important Points
IAPMO/cUPC Listed
Meets NSF 61-9
Meets A112.18.1
ADA Compliant (only K1-1401)
Standards

4
Steps 1-4
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.
1 2
Once the front wall is finished, remove the
protective caps for installing the trim.
3Install the spout to the rough and fix
securely with the two grub screws. Then
slide the central canopy over the spout,
and fix onto the escutcheon.
4Install the stem extension to the rough.
Loosen the two grub screws from the spout.
1
3 4
2

5
Steps 5-6
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.
5 6
6After installing faucet, remove aerator and
open the hot and cold supplies. Check for
leaks. Turn on faucet handle for one minute
to flush debris from faucet. Turn off the
handle and re-assemble the aerator.
5Install the handle by tightening the fixing
set screw properly.

6
Exploded View
Parts List
K1-1400
1 Handle ( C ) (506151C)
2 Screw (008233)
3 Screw (292598)
4 Stem extension (110327)
5 O-ring (072028)
6 Canopy (018964)
7 Escutcheon (071475)
8 O-ring (004009)
9 Aerator housing (305779N-54)
10 Aerator insert (553661N)
11 Oil-seal (010805N)
12 Spout assembly (139646W)
13 Screw (008198)
14 O-ring (004007)
15 Canopy (018965)
16 Escutcheon (071271)
17 Handle ( H ) (506151H)
18 Allen key (031000)
1
2
3
4
5
6
7
8
15
16
17
18
14
13
12
11
10
9

7
Exploded View
Parts List
K1-1401
1 Handle ( C ) (069699C-50)
2 Adaptor (067964)
3 Screw (008744)
4 Screw (008233)
5 Screw (292598)
6 Stem extension (110327)
7 O-ring (072028)
8 Canopy (018964)
9 Escutcheon (071475)
10 O-ring (004009)
11 Aerator housing (305779N-54)
12 Aerator insert (553661N)
13 Oil-seal (010805N)
14 Spout assembly (139646W)
15 Screw (008198)
16 O-ring (004007)
17 Canopy (018965)
18 Escutcheon (071271)
19 Handle ( H ) (069699H-50)
20 Allen key (031000)
1
2
3
4
5
6
7
8
9
10
11
12
13
15
16
14
17
18
19
20

For additional assistance or service call
718-302-5292
9am to 5pm EST Monday to Friday
LEFROY BROOKS INC, 1828 TROUTMAN STREET, RIDGEWOOD, NY, 11385
TELEPHONE: [phone]. FAX: [phone]
The use of trademarks, product design and artwork is subject to licence or agreement with LBIP Ltd. The design
registrations, trademark registrations and copyrights are protected by law and the use or reproduction outside the terms of an agreement is prohibited.
The right to modify designs and dimensions is reserved. Christo Lefroy Brooks is a member of ACID (Anti Copying in Design).
© LBIP LTD 2012
www.lefroybrooks.com