less care LB7B User manual

www.lesscare.com
LB7B
INSTALLATION INSTRUCTIONS
BASIN FAUCET

www.lesscare.com
2
LB7B
BASIN FAUCET
PREPARATION FOR INSTALLATION
ATTENTION! Dimensions may vary by up to 3/8". It is highly recommended to pull
all dimensions of actual model for installation and measuring purposes.
ATTENTION! Measurements in inches are rouned to the nearest 1/8".
TECHNICAL DATA
Max flow rate 1.2 GMP at 60 PSI
10 1/8"
3 5/16"
6"
6 1/8"
8"
2 3/8" 2 3/4"
2 7/8"

No
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
Component
Spout Pipe
Joint
Washer
Aerator
Aerator House
Canopy
Handle Shaft
Joint
Washer
O-Ring
Coil Spring
Cover
O-Ring
Joint
Cartridge
Control Body
Washer
Washer
Lock Nut
Joint
Flexible Hose
Joint
O-Ring
Joint
Washer
Lock Nut
Washer
Cartridge
O-Ring
Cover
Take Over
Coil Spring
Joint
O-Ring
Pop-up
TOOLS REQUIRED FOR INSTALLATION
Soft Cloth
or Blanket
Silicone Tape
Measure
Pencil/Marker
Safety Glass LevelKnife Caulk Gun Adjustable
Wrench
Channel
Lock Pliers
Hammer
OTHER TOOLS MAY BE REQUIRED
www.lesscare.com 3
LB7B
BASIN FAUCET
PARTS & COMPONENTS
1
2
3
4
5
67
8
9
10
11
12
13
14
15
16
17
18
19
35
21
22
23
24
25
26
27
28
29
30
31
32
33
34
20

www.lesscare.com
4
LB7B
BASIN FAUCET
INSTALLATION INSTRUCTIONS
You should clean all the dirts from valve
outlets. Turning off the water supply
valves. This is usually found near the water
meter. If you are replacing an existing
faucet, remove the faucet from the sink
and clean the sink surface thoroughly.
Place Mounting Nut, Metal Washer and
Rubber Washer over Valve Shank. From
underside sink, insert valve body through
mounting holes. The hot valve, labeled with
red tag should be positioned to the left side
of the spout.
From underneath sink, tighten Mounting
Nut by Hand. Before final tightening, make
sure Valve Body Side Connector facing
Spout Body.
Connect Spout hot water flexble hoses to
the Left Valve Side Connector. Tighten
flexible hoses Nut. Connect Spout cold
water supply line to the right Valve Side
Connector.
Make sure the O-Ring is in side the Joint,
and connect the Joint to the main body.
Connect hot and cold water flexible hoses
to faucets inlets.
As shown. lnsert Flange with Washer
through Sink drain Hole. From underside,
thread Drain Body into Flange. Holding the
drain body in position with Ball Rod
Opening facing back, tighten Metal
Locknut securely. Thread Drain Tailpiece
into Drain body.
By rotating the handle closed to the spout,
the Valve will be activated allowing water
to flow. The water flow will increase by
continuing to rotate handle .By rotating
the right handle to the left, the water
temperature will decrease to cold flow
only. By rotating handle left to the right,
the water temperature will increase to hot
only.
After installation is complete, remove
aerator and rotate handle to the close
position. Turn on the Water Supply Valves,
and check all connections for leak. Turn on
your faucet and allow both hot and cold
water to run at least one minute each.
Replace Aerator.
1 2
4 5 6
798
3
90 90
Close
Hot
Close
Cold
Open Open

www.lesscare.com 5
LB7B
BASIN FAUCET
Thank you for using LessCare products!
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
INSTALLATION OF LESSCARE PRODUCTS BY AN
INEXPERIENCED INSTALLER MAY RESULT
PERSONAL INJURY OR DEATH!
INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING
OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
LessCare reserves the right to change, update, modify, alter, redesign this manual/product or its policies without prior notice!
It is your responsibility to visit website to download or contact customer service for the most updated version of the installation instructions.
LessCare shall not be liable for any injuries or property damages in connection with this product during installation or use of this product!
LessCare products must be installed by a fully insured and licensed plumber only. Installation of any LessCare product by anyone
other than fully insured and licensed plumber shall void limited warranty. LessCare recommends that such licensed plumber have
experience in the installation of products.
Limited warranty is void on any commercial installation
LessCare is not responsible for local code compliance for this product. Building and plumbing codes may vary from state-to-state in
accordance to your location. LessCare is not resonsible for providing any compliance certifications.
LessCare is not responsible to provide any type of certifications for this product
Under no circumstances LessCare shall not be liable for any and all incidental damages sustained in connection with this product
Neither manufacture, nor distributor, nor retailer is responsible for water damage or flood caused due to use of this product.
Under no circumstances LessCare shall not be liable for any and all fees, cost of installation/reinstallation/removal, subsequent
damage or transportation in case of the product defect
Retain these installation instructions for future reference!
Maintenance & Care
IMPORTANT!
DO NOT USE: Abrasive cleaners such as: acid, ammonia, bleach, and simmilar solutions. Use of such solutions may cause corrosion,
finish peeling, and/or dull the surface.
DO NOT USE: Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch the surface.