LEVIOR 23657 Instruction manual

MANUAL FOR USE
Sawhorse
23657, 23657.02
SAFETY INFORMATION
FOR YOUR SAFETY, PLEASE ENSURE YOU READ THESE INSTRUCTIONS CAREFULLY
BEFORE USE, AND KEEP THESE INSTRUCTIONS IN THE WORK SPACE WHERE THE
SAWHORSE WILL BE USEDAT ALL TIMES.
SAFE OPERATION ANDUSE OF THIS SAWHORSE
1. When lifting the sawhorse use proper lifting techniques to avoid personal injury.
2. Ensure work area is well lighted while working.
3. Ensure saw horse is standing on a level surface that is clear, dry and free of debris.
4. Ensure all 4 legs have solid contact with the floor. If the saw horse is not positioned level and
straight, loads placed upon it could fall, potentially causing damage to the item(s) loaded on it,
and possible severe personal injury or death.
5. Ensure the load placed on any sawhorse does not exceed the applicable Safe Working
LoadRating. Overloading can lead to failure of the sawhorse, potentially causing damage to the
item(s) loaded on it, and possible severe personal injury or death.
6. Never stack sawhorses to obtain extra height.
Caution:
Do not apply weight in excess of 1,300 lbs (590 kg) of uniformly distributed load on Sawhorse.
Do not use as a step ladder or standing platform.
Tovačovská 3488/28, 750 02 Přerov
CZECH REPUBLIC
Tel.: 00420 - 581 - 746256-58
Fax: 00420 - 581 - 746255
E-Mail: [e-mail]
Web site: www.levior.cz

Uniformly-Distributed Load
The maximum uniformly distributed load across the top rail of the saw horse, PER EACH SAW
HORSE:
This means that the maximum weight that can be applied to this saw horse, per lineal foot, as is
stated on the Retail Sticker and the instructions. Uniformly-Distributed Load" means when all the
weight is distributed evenly on the top rail. The amount of weight that can be applied to 2 identical
saw horses is double this value. For example, a pallet or skid weighing not more than two times the
Safe Working Load Rating can safely be carried by 2 of these saw horses.
WARNING! TO REDUCE THE RISK OF PERSONAL INJURY, USER MUST READ AND
UNDERSTAND OPERATOR'S MANUAL. LEGS MUST BE LOCKED OPEN. DO NOT STAND ON
SAWHORSE. DO NOT OVERLOAD. MAXIMUM CAPACITY 1,300LBS. USE ONLY ON A FLAT,
DRY, HARD AND LEVEL SURFACE.
SET-UP INSTRUCTION
1. Sawhorse in folded/carry position.
2. Above location labeled "Pull 1", press
release button and pull down legs until 2x4
supports are fully deployed.
3. Separate legs and push cross brace flat.
4. Above location labeled Pull 2", press
release button and fold down legs until 2x4
supports are fully deployed.
5. Separate legs and push cross brace flat.
6. Legs adjust in increments of 1 inch. To
extend, pull legs down until latch is locked
at desired position. To retract, press lock
button, pull legs down slightly then push leg
up.

7. Pls loosen the knob and adjust the bracket
to the required width and tighten the knob.
The range is from 37mm to 90mm to fit
different size of plank.
8. When paired together with a second unit
and properly joined by 2x4's in the support
arms, a work table can support up to 2,600
lbs (1180kg).
HOW TO CLOSE
1. To close, reverse steps 5 through 2, starting with leg 2.
2. Be sure locking pin engages main housing to keep legs secure while in folded/carry position.