U-Line ih-1060 User manual

1211 IH-1060PAGE 1 OF 2
PARTS LIST
TOOLS NEEDED
Board (E) or Wire (F) x 3 (or 6)
ASSEMBLY
NOTE: Lean posts against a wall or assemble with
another person.
1. Connect two upright posts (A) by inserting a side
support piece (B) at the bottom and top of the posts.
(See Figure 1)
2. Repeat step one for the other two upright posts (A).
Rubber Mallet
Figure 1
B
A
B
Upright Post x 4 (A) Center Support x 3 - 9 (D)Side Support x 6 (B) Front/Back Support x 6 (C)
WIDE SPAN
STORAGE RACKS
NOTE: Boards and wire
come as two pieces for 60,
72, and 96" wide racks.

1211 IH-1060
3. Place side support pieces (B) in the middle of the
upright posts at desired middle shelf height.
(See Figure 2)
4. Connect the two upright post assemblies by inserting
front/back supports (C) at the top and bottom of each
upright post. (See Figure 3)
NOTE: Be sure the supports are fully seated before
continuing with assembly.
5. Repeat step 4 for installation of all other front/back
supports.
6. Attach shelf supports (D) at each level by placing the
keyhole slots (on shelf support) over the rivets (on the
inside of the front/back support) and tapping them into
place. (See Figure 4)
Recommended number of shelf supports per shelf are as
follows:
36" / 48" / 60" W −1 Shelf Support
72" W −2 Shelf Supports
96" W −3 Shelf Supports
7. Set boards (E) or wire (F) on top of shelf supports, side
supports, and front/back supports. (See Figure 5)
PAGE 2 OF 2
ASSEMBLY (CONTINUED)
Figure 3
Figure 4
Figure 5
Figure 2
B
C
D
E
F
A