Lian-Li UNI FAN SL RGB User manual

- 1 - - 2 -
安南
INSTALLATION GUIDE
FAN CONNECTION FAN
風扇連接風扇
FAN CABLE INSTALLATION
風扇線材安裝
UNI FAN SL
Revolutionized Daisy-Chain ARGB Fan
RGB
1
2
1
2
Fixed
Release
Fixed Release
Note! When using the UNI FAN SL in a custom water cooling configuration, make
sure that the fittings on the radiators do not interfere with the contact point on the side
of the fans. We suggest to use the insulating tape to isolate contact points.
在定義冷配置中UNI FAN SL，󰇽確保散󰆆器上的配不會干擾
風扇側面的接觸點，議絕緣膠帶隔󰔵接觸點。
注意!

- 3 - - 4 -
Connect to PSU SATA 15 Pin
CONTROLLER CABLE CONNECTION
控制器線材連接
1VCC
2
4GND
DI
5V+/5V-
Serial ATA
1
15
P1
515
11
Connect to 5V ARGB
3 pin header
Connect to USB
Connect to fan
MOTHERBOARD 5V ADDRESS
LED HEADER
MOTHERBOARD SYNC
主機板 SYNC
ADDRESS LED header
+5V1 2 Data
No Pin3 4 Ground
1VCC
2
4GND
DI
Press and
pull out the connector
to release the cable
警告: 請不要連接錯誤類型的
LED 接頭，如果連接到12V接口
，將造成永久損壞。
Warning: Do not connect the
wrong type of LED connector.
If it is connected to the 12 V
connector, it will cause damage.
Split cable
1VCC
2
4GND
DI
1VCC
2
4GND
DI
!
控制器
Controller
GROUP 2 GROUP 1
GROUP 4 GROUP 3
Connect to
GROUP 1, or
GROUP 2, or
GROUP 3, or
GROUP 4.
G50.12UF00.01