LifeSpan Kids Topaz 2 in 1 Slide User manual

WARNING: Keep away from re. The disassembled product contains small parts which pose a choking hazard to children under 3.
Topaz 2 in 1 Slide Owner’s Manual
I. GENERAL SAFETY INSTRUCTIONS
This product is intended for use indoor or outdoor and domestic use only. It is not suitable for commercial use.
•Do not use the product if it is damaged or defective. If it is damaged or defective, please contact a qualified technician.
•Check the product before each use. Defective parts must be changed immediately as they can impair the function and the
safety of the product.
•No more than one person to use the product at the same time.
•Use the product only on even and non-slip surfaces. Keep sufficient space around for safety.
•Do not swing while standing or slide down head first.
•Do not make alterations to the product. Only use original spare parts. Only qualified technicians should carry out repairs –
improper repairs can lead to danger for the user. Use this product only as described in this manual.
•The assembly of the product must be done carefully and by an able-bodied adult. If in any doubt, ask a technically
qualified person.
•Before you start with the assembly, read the instructions carefully.
•Remove all packaging materials and lay down all parts on an open space. This gives you an overview and simplifies the
assembly procedure.
•Check with the parts list that all parts are available. Dispose of the packaging material when the assembly is completed.
•Beware that when using tools or doing technical work, there is always a risk of injuries. Assemble the product with care.
•Create a danger free environment; for example, do not let tools lay around the workspace. Store the packaging material in
a way that cannot cause any danger.
•After installing the product according to the instruction manual, ensure all screws, bolts and nuts are correctly installed
and tightened and that all joints are secure.
•Place the play equipment on a level surface at least 2m from any structure or obstruction.
•Do not use volatile chemicals like thinner and benzene while cleaning.
•Use warm soapy water to clean.
•Adult assembly required
•Make sure plastic nuts are secure at all times.
•To be used under adult supervision.
•This is designed for children over 12 months.
•The maximum weight of the user should not exceed 25kg.
1.1 DANGER FOR CHILDREN
1.2 RISK OF INJURIES
1.3 PRODUCT DAMAGE
1.4 ASSEMBLY ADVICE
1.5 CLEANING ADVICE
1.6 SAFETY INFORMATION
II. WARRANTY
AUSTRALIAN CONSUMER LAW
Many of our products come with a guarantee or warranty from the manufacturer. In addition, they come with guarantees
that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage.
You are entitled to have the goods repaired or replaced if the goods fail to be of acceptable qualityand the failure does not
amount to a major failure. Full details of your consumer rights may be found at www.consumerlaw.gov.au.
Please visit our website to view our full warranty terms and conditions:
www.lifespankids.com.au/Warranty-Policy-Kids

III. ASSEMBLY INSTRUCTIONS
IMPORTANT:
The owner’s manual contains safety, assembly, use and maintenance instructions. The product must be assembled by an
adult who has read and understood these instructions. Keep the packaging away from children and dispose of all packaging
before use. For the installer and your children’s safety, it is important to fully read and understand the instructions and safety
hazards before commencing the assembly of the product.
1 2 3 5
4
6
7
Parts
Part 1: 2pcs.
Part 2: 1pc.
Part 3: 2pcs.
Part 4: 4pcs.
Part 5: 1pc.
Part 6: 13pcs.
Part 7: 1pc.
Stickers
1 2 3
6 x 12
6 x 1
Please refer to the
below drawings and
put the sticker on.
(Side Panel)
Step 1:
1. Insert 1x Part 3 into 1x Part 2.
Step 2:
1. Attach 1x Part 2, 4x Part 4 and 1x Part 3 onto 2x Part 1, secure with 12x Part 6.
Step 3:
1. Attach 1x Part 5 to 1x Part 1 with 1x Part 6.
2. Tighten all plastic nuts before use.
3. Attach stickers as shown in image