Light Blue Optics Light Touch LT1020 Series User manual

bbb
5000 0040 Light Touch LT1020 Series – Quick Start Guide v2.1 | P a g e 1
LightTouch LT1020 Series – QuickStartGuide
1. Remove from packaging and peel off protective films
Check package contents against packing list
2. Fit base-plate
Fit the base-plate to the unit using the M5 screws provided, as shown in Figure 1.
3. Unscrew battery bay and remove
See Figure 3 and 4. The label on the battery bay shows which screws to remove
Figure 3
Unit with
battery bay
closed.
Arrows show
which screws to
remove
Figure 4
Unit with
battery bay
open
Figure 1
Fitting the
baseplate
Figure 2
(A)DCpower
input (B)
on/off button
A
B
Only use the M5 flat
head screws provided
NOTE: The Light Touch unit has no user-serviceable parts and should not be disassembled except by
qualified service personnel. Please return to Light Blue Optics for servicing.

bbb
5000 0040 Light Touch LT1020 Series – Quick Start Guide v2.1 | P a g e 2
4. Connect battery into board
The LT1020 unit is shipped with the battery disconnected in order to prevent
discharge of the battery. The battery connector is keyed and should be
connected together with the speaker as shown in F i g u r e 5.
5. Fit battery bay and screw on
As shown in Figure 3.
6. Place on flat surface, ideally matte white
For best image brightness and colour fidelity use a matte white surface, e.g. paper.
7. Plug in power and turn unit on
The 5V DC power input inserts into connector A in Figure 2. The unit can then be
turned on by pressing the on/off button shown as B in Figure 2. The unit will
display a loading screen for approximately 5 seconds before starting an initial
application.
8. Interact with application by touch
The projected image is touch enabled and applications can be controlled by
touching buttons and control elements with a finger as s hown in Figure 6.
Figure 5
Battery connected into board
Figure 6
Interacting with an
applicationby
touching the
projected image
Speaker
connector
should be
inserted as
shown
Power
connector
should be
inserted as
shown
NOTE: The Light Touch unit has no user-serviceable parts and should not be disassembled except by
qualified service personnel. Please return to Light Blue Optics for servicing.