P. T. F. 604.464.5644 1.800.464.9544 604.464.0888
R3P-F-R-T-installation • Subject to change without notice • REV 2021.10.19
Install Guide
R3P-F-R-T
NON-I/C BASEPLATE
This product must be installed in accordance with the
applicable code by a person familiar with the construction
and operation of the product and the hazards involved.
Read all of these instructions before installing.
WARNING: Rated for non-insulated ceilings only (non IC rated)
WARNING: Disconnect power prior to servicing or installing.
Align holes and screw
brackets to base plate.
Slide and click tabs onto
plate. Ensure mounting
holes line up for step 2a.
1
Slide hanging bars onto
assembled base plate.
3
Line up bottom edge of
hanging bars with bottom of
wood joist and hammer in
tabs. Nail or screw hanging
bars into place
4
2
3a — Position trim hole to
desired location by sliding
housing
3b — Use centering holes on
either side of base plate to
line up a row of fixtures
5a
5b
To lock baseplate in place,
bend tab with pliers over
hanging bar.
56
Mark approximate fixture
location in ceiling
7
Cut open using baseplate
hole as your guide
8
1
