Lights LampLust Elloway User manual

1
INSTALLATION INSTRUCTIONS NO. LC005059
1
IMPORTANT
Before using your LampLust Elloway Solar Lantern Wall Lights, please
make sure that you carefully read through these instruction sheets.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations that
may occur. It must be understood that common sense, caution and care
are factors that can’t be built into any product. This approach must
be used by the person(s) caring for and operating the solar lights.
GENERAL INFORMATION
Battery installation should only be performed by an adult. Only batteries
of the same of equivalent type as recommended should be used. Battery
leakage can cause corrosion and damage to this product so please
remove non-functioning batteries immediately. Remove batteries from
product during long periods of non-use. DO NOT DISPOSE OF IN FIRE.
Please dispose at your local recycling facility.
STEP BY STEP INSTRUCTIONS
Before operating your solar lights, remove the battery tab from the
battery compartment (located inside the lantern, under the solar panel),
thereby activating the batteries.
CHOOSING THE RIGHT LOCATION
Before installing the solar lights, you will need to
select the right location for installation. The solar
lights need to be in a non-shaded area where
sunlight is not obstructed by buildings, walls, fences,
trees, bushes or any shadows that these objects
create throughout the day. Shady locations will not
allow the battery to fully charge and may reduce the
time the solar lights stay on. Avoid proximity to other
light sources, which may cause the solar lights to not
operate correctly. Make sure solar lights are placed at
least 6 feet apart to prevent light interference.
WHAT WE PROVIDE
• 2 - Elloway Solar Lantern Wall Lights
• 2 - Wall Hooks
• 2 x AA LiFePo4 Rechargeable Batteries (Installed)
(1 Per Path Light)
•Mounting Hardware

INSTALLATION INSTRUCTIONS
2
NO. LC005059
4
2
REMOVE PULLTAB
Remove top cap by turning counter-clockwise.
Remove pull-tab. Re-install top cap by turning
3
INSTALL BACK PLATE
Using the 2 screws provided, attach back plate to the
desired location. Hang the wall light on the hook.
SOLAR CHARGING
Maximum sunlight will give the internal battery the
best charge and give you the best results. The solar
wall light will not be very bright or long lasting, until
the battery is fully charged. Once charged, the wall
light will turn on at dusk and remain on for up to 8
hours, depending on the charge received that day.
NOTE: You may charge the battery in a battery charger,
or charge it with the solar panel. When using the solar
panel, be sure that the battery receives a full day’s

INSTALLATION INSTRUCTIONS
3
NO. LC005059
TROUBLESHOOTING
• Solar lights not operating properly at night may be caused by one of the following conditions:
• Low light levels during the day, caused by the position in which the light is placed, weather conditions, or lack of sunlight, will shorten the
solar lights’ operating time at night.
• If the surface of the solar panel is dirty, the charging ability will be reduced. Clean the surface occasionally with a damp cloth.
• The batteries might need to be replaced. In the event that they do need replacing, see “BATTERY REPLACEMENT” above.
• Please note that solar lights will not function in the daytime or in a brightly lit environment.
5
BATTERY REPLACEMENT
Batteries may need replacement every 1-2 years,
depending on the operating conditions. To install a
new battery, remove the top cap by turning it
counter-clockwise. Remove the battery compartment
cover and replace battery. When installing a new
battery, be sure to insert with the correct polarity as
indicated (+/-) and secure the battery compartment
cover. Re-install the top cap by turning it clockwise
and place the wall light onto the hook.