LIGHTSCAPES Bird Oasis User manual

Please read instrucons before assembling.
Check Out Other Lightscapes Products At www.lightscapesllc.com
Lightscapes LLC • 5889 N 700 W—1 •
Craigville IN 46731 • Ph: 260-701-0345 Built In The USA!
Form 500-0032 5/18
Patent Pending
Patent Pending
By Lightscapes LLC
Bird Oasis
TM
Servicing the Fountain
Over me the fountain can be clogged with foreign debris. To service the
fountain, li the fountain o of the ower pad, remove the fountain head and
ip the fountain upside down. Next remove the water pump (do not disconnect
the wire). Take out the rotor with the included tweezers and the lter coon and
clean all exposed parts using warm soapy water. Reassemble the fountain. See
drawing below:
QUESTIONS? Contact us!
Phone: [phone] • Email: [e-mail]
Keeping your Bird Oasis Clean
Eventually algae can grow in your bird bath. Prevenve measures can greatly
reduce the amount of algae and how oen your bath needs to be cleaned.
Lightscapes has an algae inhibitor available. Simply call us or visit our website
to order. When you do need to clean your Bird Oasis, rst use vinegar or
bleach to GENTLY wash the oang ower pad and fountain. Just gently spray
the owers to clean them. Aer cleaning the fountain and oang ower pad,
dump the old water from the barrel, clean with vinegar or bleach and then
wash with soapy water, rinse with water and rell the tub with fresh water.

Assembly of your Lightscapes
Bird Oasis™ Bird Bath
Model No. 104-0001
Tools Needed: None
Parts in the Packaging: 11.9 Gallon Barrel, Solar
Powered Fountain, 4 Fountain Clips, 7 Fountain
Heads, 1 Fountain Head Base, Floang Flower Pad
with Bath Tub.
Step One: Take Items out of box and make sure all parts are included.
Step Two: Place your Bird Oasis™ barrel where you plan on leaving it. Make sure
the surface is at and level and has maximum exposure to sunlight.
Step Three: Fill the barrel to one-half inch below the rim, with clean water.
Step Four: Choose the fountain head you want to use and push the boom onto
the center hub of the fountain base. Note: see next page for fountain head types.
Step Five: Install four fountain clips onto the fountain (see photo A. below).
Step Six: Place the oang ower pad into the water.
Step Six: Place assembled fountain onto oang ower pad. NOTE the fountain
clips rest on top of the ower pad (see photo B. below).
Step Eight: ENJOY!
Choosing The Fountain Head
The Fountain comes with seven dierent heads that will create dierent water
paerns. They are easily installed and changed to suit your preference.
Fountain heads B1, B2, B3, and B4 install directly onto the fountain. Fountain
heads B5, B6 and B7 install on fountain head base B8 and the assembly installs
onto the fountain by pushing it onto the center hub on the base. If you live in a
windy area, Lightscapes recommends using fountain head B1 or B3.
Spray Paern By Fountain Head
Photo B.
Photo A.