LIHUIYU M2 User manual

LIHUIYU M2 Nano Laser Controller Set
Features:
M2 motherboard is a square port USB interface motherboard:
1. Support carving, cutting, image engraving, slow marking
2. Support for receiving unlimited number of engraving data
3. Support USB dropped breakpoints continued
4. Support unlimited engraving formats
5. Support USB dropped detection
6. Supports accidental breakpoints
M2 Nano Laser Controller Motherboard:
1. X-Axis Stepper Motor
2. Y-Axis Stepper Motor
3. LO: Laser Control Signal Output. Low Level (≤0.3V), Laser On. High Level (5V), Laser Off.

4. LO: Connect to Power Supply ‘TL’Port
5. External Synchronous Control Signal Output
6. USB Port
M2 Controller Panel:
1. Digital Display for Laser Energy Percentage
2. Laser Energy Settings Button: used to set laser energy, with a range of 0% to 99.9%. The setting
accuracy is 0.1%.
3. Turn Off the Laser: Press the two buttons at the same time to force the laser off. Press any button
again to restore the original data.
4. Laser Status Indicator
5. Test Button
6. Connect to Laser Power Supply.

Wiring Diagram:

Packaging List:
1PCS M2 Nano Laser Controller Motherboard
1PCS M2 Controller Panel
1PCS Cable
1PCS USB Dongle
Made in China