LIM Adventurer User manual

SETTING THE POLE LENGTH
To set the length of the poles for your height, extend the bottom
section just to the “Stop” mark, leaving the “Stop” mark hidden
just inside the pole. Next, extend the middle section so that when you hold
the pole to your side, as if you were hiking, your arm is bent at a ninety degree
angle. The middle section is marked in centimeters so you can take note of your setting and use
that to quickly set the pole length in the future. For hiking uphill any great distance, adjust the
poles to be a little shorter. For hiking downhill, adjust the poles to be a little longer.
Adventurer Trekking Poles
Quick Start Guide
ADJUSTING THE LOCK TENSION
If a lock seems too easy or too dicult to close, with the lock in
the open position, increase the lock tension by turning the tension
screw clockwise or decrease the tension by turning it counterclockwise. Test
in ½ turn increments until satised. Do not over tighten. Check lock tension
before every use to prevent loss on the trail.
BASKET INFO AND USES
Two types of baskets are included: a pair of
mud baskets (the smaller basket pictured)
and a pair of snow baskets (the larger basket pictured).
Baskets are used when conditions are muddy or snowy to
add surface area which helps prevent the pole from sinking too deep in the snow or mud. When
attaching a basket, push the basket onto the threads with enough force to contact the threads while
turning clockwise. Do not overtighten.
EXTENDING AND COLLAPSING POLES
To extend or collapse the poles, simply open
the lock of a section and adjust that pole
section to the desired length. Once set, close the lock and
that will hold the section in place. When extending the
pole sections, do not extend past the “Stop” mark. The “Stop” mark should not be showing or it
will cause the pole to be susceptible to breaking.

USING AND ADJUSTING THE STRAPS
To use the strap, put your hand through the
strap from the bottom and grip the pole over
the strap as shown in the picture. To adjust the straps, pull
on Strap A to dislodge the clamp (B). Then, to loosen the
strap, hold clamp B while pulling on strap D. To tighten
the strap, hold strap C while pulling on strap A. When
nished adjusting, pull on strap C until clamp B is back
inside the grip.
TIP INFO AND USES
The rubber tip protectors are meant to be
used on hard surfaces such as pavement and
gravel. For use on natural trails, remove and store the tip
protectors and hike with the durable tungsten steel tips.
The steel we use on our Adventurer trekking poles will last you a long time. But even as strong as
we've made them, they will eventually wear out. That's why we've made these so that they screw
on, allowing you to replace them whenever they nally run out of mileage. They can be removed
by loosening them with a pair of pliers and then unscrewing them by hand.
PACKING THE POLES
The poles collapse to 27" which will t in many medium to large
suitcases if packed corner to corner. You can also completely
disassemble the poles and the longest piece will be 20.5" which should pack nicely
in most luggage including many carry-ons. When completely disassembling,
there is the possibility of the locking clamps falling o, so we suggest that you take o all of the
locking clamps and pack them in a sandwich bag during travel. When reassembling, please note
that the clamps on the lower section of the poles are smaller than the clamps on the upper section.
CONTACT INFO
Thank you for purchasing our Adventurer trekking poles. This quick start guide is
meant to get you out on the trail as quickly as possible so you can keep living life in
motion. Should you have any questions, you can contact us by phone, email, or through the website.
• Call us toll free at (844) LIM-4YOU [[phone]]
• Email us at [email protected]
• Message us at www.lifeinmotionproducts.com