Linx HumPRO Series User manual

HumPROTM Series Master Development System
Quick Start Reference
Remove Contents
Remove kit contents including development boards,
antennas, batteries, modules and USB cables.
1Set Up the Programming Docks
With the power off, set up boards by inserting EVMs into
sockets on the Programming Docks and attaching the
antennas.
2
Revised 7/27/2017
Install the Windows software from the
CD that is included with the kit. If already
installed, skip this step.
Install the Software
3
Connect the Programming Docks to a
computer with the cables included with
the kit. USB drivers are on the CD so
install them if prompted by the computer.
Connect the Programming Docks
4
Start the software. It automatically
detects conected modules and reads
their configurations.
Start the Software
5
MDEV-fff-PRO MDEV-A-fff-PRO
Connect the antenna
to the Carrier Board

EX
CRESP
MODE_IND
CMD_DATA_IN
PB
CMD_DATA_OUT
VCC
POWER_DOWN
RESET
LNA_EN (NC on amplified)
PA_EN (NC on amplified)
CMD
CTS
BE
Warning: Installing or removing a Carrier Board
while power is applied could cause permanent dam-
age to the module. Either turn off power to the board
or unplug the USB cable before installing or removing a
Carrier Board
!
Note: The LNA_EN and PA_EN lines are not wired out
on the HUM-A-900-PRO.