Litelink ACC-1001 User manual

WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested
prior to shipment and are warranted against defective materials
and workmanship for a period of five full years from the date of the
original shipment. Should a problem occur, a Return Material
Authorization Number (RMA) must be obtained from Liteway Inc.
at [phone] and the item returned to Liteway, Inc. 166
Haverford Road, Hicksville, NY 11801, USA, prepaid. Liteway Inc.
will then, at its option repair or replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the
cost of the defective item only. No contingent liabilities of any kind
are either assumed or implied.
Any items returned to Liteway, Inc. that have been misused,
abused, damaged, modified, connected or adjusted in any way
contrary to the instructions furnished by Liteway, Inc. or repaired
by unauthorized personnel will not be covered by this warranty.
Any non-warranty repairs required will be quoted at the current
rate for such services.
Important Notices
CAUTION ! AVOID DIRECT EXPOSURE TO BEAM.
All -7,-8, and -9 Models use laser diodes. These solid-state laser
diodes are located in the optical ports of these units. Laser diodes
produce invisible radiation that may be harmful to human eyes.
Never look directly into the optical port of any fiber optic unit
designed to operate with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications
of any kind.
© Copyright 2017 Liteway, Inc. 138434 Rev A
OPERATING INSTRUCTIONS
Litelink®
Fiber Optic
Intercom Accessories
Models; ACC-1001, ACC-1002,
ACC-1006, ACC-1009
The various Fiber Optic Intercom Accessories described in the
manual are all designed to be used with the INCX-4001 standard
Intercom system.
All items plug directly into the front
panel connector on the INCX-4001
!

ACC-1001
The ACC-1001 is a standard inexpensive
headset/microphone combination that can
be used with the INCX-4001 when more
privacy than the standard push to talk
scheme is capable of.
ACC-1002
The ACC-1002 is a standard telephone
type handset that can be used with the
INCX-4001 when a handset is required.
138434 Rev A
ACC-1006
The ACC-1006 is a wall mountable handset
hanger for use with the ACC-1002 handset.
ACC-1009
The ACC-1009 is a standard push-to-talk
microphone that can be used with the
INCX-4001 when a push-to-talk microphone
is required.
Installation Instructions
All items plug directly into the front panel connector on the
INCX-4001.