Litelume Sports Lighter Small User manual
Sports Lighter Small
Installation Instructions
LITELUME™ seeks to deliver the most advanced and efficient LED technology. Due to
technology progression, specifications may change. We reserve the right to update product
specifications without notice. Contact LITELUME™ for the most up-to-date data.
www.litelume.com
833.LED.LUME
Page 1/3
Rev Date: 08/19/2018
©Lite Lume Corporation 2018
Warning
1.To avoid electric shock, disconnect power at source prior to installation.
2.The installation should be performed by qualified electricians or lighting technicians.
3.Before conducting any installation, maintenance, or removal, disable all power to the luminaries and wait until the fixture cool
down.
4.Do not touch the fixture while it is in service.
5.If there is any problem with the fixture, DO turn off power and DO NOT attempt repair unless you are a qualified technician or
the customer service member.
Light Barrier Installation Instructions
Heat sink
Lightbarrier
Put the light barrier on the lamp body
M5*12mm Hex Screw
Use 6 pcs of M5*12mm Hex Screw to unlock
the light barrier on the lamp body
Installation Instructions
1. Fix the M20 bolt at the mounting surface plate.
2. Fix the rotatable bracket on the M20 bolt.
M20 Bolt
Mounting surface plate
3. Put the plain washer& lock washer in the M20 bolt.
Sports Lighter Small
Installation Instructions
LITELUME™ seeks to deliver the most advanced and efficient LED technology. Due to
technology progression, specifications may change. We reserve the right to update product
specifications without notice. Contact LITELUME™ for the most up-to-date data.
www.litelume.com
833.LED.LUME
Page 2/3
Rev Date: 08/19/2018
©Lite Lume Corporation 2018
4. Fasten the nut, fix the light on the mounting surface.
M20 Nuts
5. Adjust the beam angle.
6. Lock the binding bolt to fasten the light body.
Bindingbolt
Beam Angle Position
240°Beam anglerotatable
Min installation position Max installation position
Sports Lighter Small
Installation Instructions
LITELUME™ seeks to deliver the most advanced and efficient LED technology. Due to
technology progression, specifications may change. We reserve the right to update product
specifications without notice. Contact LITELUME™ for the most up-to-date data.
www.litelume.com
833.LED.LUME
Page 3/3
Rev Date: 08/19/2018
©Lite Lume Corporation 2018
Wiring Diagram
For 0-10V Dimming Version, please refer to wiring diagram below.
Troubleshooting
1. Check that the line voltage at the fixture is correct. Refer to wiring diagram above.
2. Is the fixture grounded properly?
3. Be sure the photocell, if used, is functioning properly.
Table of contents
