LivePure AquaFlame LP300HUM User manual

AquaFlame Ultrasonic Humidier
Owner’s Manual
Models:
LP300HUM
(All Colors)
Form #LP300HUM
08012023
© 2023 Registered Trademark/ TM Trademark of LivePure LLC.
Manufactured exclusively for LivePure LLC.
All rights reserved.
READ AND SAVE THESE INSTRUCTIONS
English

Table of Contents
At a Glance
Warnings & Know Your Humidier .......................................... 2-3
Operating Your Humidier
Initial Setup ............................................................................ 4
Humidier Operation ......................................................... 5
Maintenance .......................................................................... 6-7
Humidier Assistance
Troubleshooting ................................................................... 8
Technical Support ................................................................ 9
Warranty .............................................................................................. 10-12

Thank you for purchasing the AquaFlame Ultrasonic Humidier from LivePure®
Company. Please read and save these instructions to receive the maximum benet and
performance from your humidier.
READ AND SAVE THESE INSTRUCTIONS!
Important Safety Instructions:
Read all instructions before using this humidier
• This humidier may not work properly on an uneven surface. ALWAYS place this
humidier on a rm, level, and water resistant surface.
• ALWAYS place the humidier at least six (6) inches away from walls, heat sources,
and electrical appliances such as stoves, radiators, or heaters.
• ALWAYS place the humidier in an area that is out of the reach of children.
• Before using the humidier, extend the cord and inspect for any signs of
damage. DO NOT use the product if the cord has been damaged.
• Use only the LivePure AC adapter intended for this product, model LP300HUM.
Using any other AC adapter can damage the humidier and may void your
warranty. Do not use the power cord supplied with the AC adapter with another
instrument.
• Do not disassemble or modify the AC adapter.
• Do not use the AC adapter outdoors or in locations subject to rain, water, heat,
re or sun.
• Never wrap a power cord around an AC adapter or other object. Doing so can
stress the cord in ways that can cause the cord to fray, crack, or crimp. This can
present a safety hazard.
• Protect power cord and AC adapter from liquids. Do not leave power cord or AC
adapter near sinks, tubs, toilets, or on oors that are cleaned with liquid cleaners.
Liquids can cause a short circuit.
• Ensure that all power cord connectors are securely and completely plugged into
receptacles.
• Do not use any AC adapter that shows corrosion or signs of overheating.
• To prevent possible overheating, do not cover the AC adapter with clothing or
other objects when the AC adapter is plugged into an electrical outlet.
• ALWAYS UNPLUG AND EMPTY the humidier when it is not in operation or while
it is being cleaned.
• Use only clean, cool tap water when lling the tank. DO NOT use hot water.
• Never add medication of any type to the water tank.
At a Glance
Warnings & Know Your Humidier
2

• You should never leave the unit unattended in a closed room. The room can
become saturated and leave condensation on walls and furniture. Always leave a
door partially open.
• This device complies with part 18 of the FCC Rules.
• To reduce risk of re, electric shock, or injury, place the unit and cord where it is
not likely to be tipped or bumped.
• Do not overll the humidier due to potential risk of electric shock.
• ALWAYS disconnect the product from power source before performing any
maintenance or cleaning.
At a Glance
Warnings & Know Your Humidier
3
Adaptor Specications:
Input: 100 - 240V ~ 50/60Hz, 0.8A
Output: 24V DC 1000 mA

Operating Your Humidier
Initial Setup
4
Initial Setup:
1. Remove the plastic bag covering from the humidier.
2. Unravel and straighten the cord before use. Connect the adaptor to the
humidier.
3. Remove the cover from the humidier base by grasping the tab and removing
from humidier.
4. Fill the unit with clean, cool tap water up to max ll line. Do not ll past max ll
line. Figure 1
5. Place the cover back on the humidier.
6. Plug the humidier into a wall outlet and start the unit.
Figure 1

Operating Your Humidier
Humidier Operation
5
Operating the Humidier:
1. Power: Touch the power button once and the humidier will output mist on
low. Accent light will turn on. Touch the power button a second time and the
humidier will output mist on high. Touch the power button a third time to turn
o the humidier. Figure 2
2. Timer: To set time, press TIMER button. There will be a light next to the
selected time. Continue pressing the TIMER button until desired amount of time
is selected. Choose from 2, 4, or 8 hour intervals. Figure 2
3. Accent Light: Accent light will automatically come on and be displayed as blue
when humidier is powered on. To change color of the accent light, continue
pressing the ACCENT LIGHT button. Choose from blue, red, orange, green, or
pink. Press the ACCENT LIGHT button once more to turn accent light o.
Figure 2
Figure 2

Operating Your Humidier
Maintenance
6
Daily Maintenance:
Note: ALWAYS unplug the humidier from the electrical outlet before cleaning.
1. Turn o the humidier and unplug it from the wall outlet.
2. Remove the cover by pulling it straight o the humidier. Figure 3
3. Turn the humidier upside down and drain any water into a sink or tub. Shake
the unit gently to remove any remaining water.
4. Rinse the tank thoroughly with water, empty, and wipe with a clean, dry cloth.
5. Wipe the humidier base with a dry cloth if necessary.
6. Rell the tank as directed under Initial Set Up and resume use.
Cleaning the Aroma Port:
Note: It is recommended to clean the aroma port and pad after every essential oil
use.
1. Turn o the humidier and unplug it from the wall outlet.
2. Press in on aroma port to release the tray. Figure 3
3. Remove the aroma pad and rinse it out or replace with a new one.
4. Use a soft, damp cloth to clean the inside of the tray.
5. Allow both the tray and the pad to air dry.
6. Insert pad into tray, laying at, and return tray to humidier.
Figure 3

Operating Your Humidier
Maintenance
7
End of Season Maintenance:
1. Follow the instructions for weekly maintenance before storing the unit.
2. Ensure all parts are completely dry before storing the unit.
3. Store the unit in a cool, dry place.
4. Never store the unit with water in the tank.
LivePure is not liable for any damages of any kind resulting from misuse or
improper maintenance. Warranty is only valid when proper maintenance, as
stated in this user manual, has been followed, as warranties apply explicitly
to manufacturer’s defects only.
Weekly Maintenance:
1. Turn o the humidier and unplug it from the wall outlet.
2. Remove the cover by pulling it straight o the humidier.
3. Turn the humidier upside down and drain any water into a sink or tub. Shake
the unit gently to remove any remaining water.
4. Fill the water tank with a mixture of 1 cup of water and eight (8) ounces of
white vinegar. Let the mixture sit in the water tank for 20 minutes before
discarding the mixture.
5. Rinse the water tank several times with clean water. Leave the cover o to allow
the water tank to dry completely.
6. Wipe the surfaces of the humidier base with a soft damp cloth.
7. Once all the parts are clean and dry, reassemble the humidier, rell the water
tank, and resume use.
Note: Daily and weekly maintenance is necessary to prevent the growth of
bacteria, mold, and fungi.

Humidier Assistance
Troubleshooting
8
Problem: Excessive Noise
Solution:
1. Check the humidier to make sure the cover is properly seated on the base.
2. Check the water tank to make sure there are no bubbles when the water tank
is full and running. If there are bubbles, turn the unit o until the bubbling stops.
When the bubbling has stopped, set the unit to the desired speed.
Problem: Humidier not working
Solution:
1. Make sure the power button is not set to “O”
Problem: Mineral buildup on the water tank or tray
Solution:
1. Refer to the section Maintenance.
Problem: Humidity output and water usage decreased
Solution:
1. Check the Power Button to make sure it is set to the desired humidity level and
speed.
2. Check the water tank to make sure there are no bubbles when the water tank
is full and running. If there are bubbles, turn the unit o until the bubbling stops.
When the bubbling has stopped, set the unit to the desired speed.
3. Clean any components that have mineral build-up. Refer to the section
Maintenance.

Humidier Assistance
Technical Support
9
Technical Support
If you need any assistance with setup, operation, or parts for your new LivePure®
humidier, please call us. Our technical support sta is ready to help!
USA/Canada: 888-855-5426
Email: [e-mail]
Hours of operation are from 8:00 AM to 6:00 PM ET, Monday through Friday. You
may also contact us online at www.livepureshop.com.
@LivePureShop
@livepure_shop
For all of the latest updates and promotions, follow us on our
social media channels: