Logipix LPIX15-01-S-ABF User manual

Quick Installation Guide LPIX15-01-S-ABF
Installation of the Logipi 15 Megapi el ABF camera
The rear view of the camera
Remove the protective cap and mount the lens
After unpacking the camera, remove the sensor’s protective cap and mount
the lens as soon as possible to prevent sensor soiling. Standard CS- ount lens
types can be connected to the camera. C- ount lens types can be connected
with an appropriate spacer ring. Rotate the lens clockwise to fix it on the
camera. Connect the iris drive connector to the camera (if the lens has DC or P-
iris feature). The connector can be found at the back of the camera.
Connecting the LAN
Connect the CAT5 Ethernet cable with the RJ45 plug to the LPoE LAN
connector of the camera. The connector can be found at the back of the
camera. Power supply of the camera can be provided over the Ethernet cable if
it is connected to the LPoE router of the Logipix NVR.
1/3

Quick Installation Guide LPIX15-01-S-ABF
Connect the power cable
When LPoE feature cannot be utilized, a 12V DC external power supply is
necessary for the camera. Install ferrules for the copper wires of the power
supply. Use a crimping tool to perform this process. Connect the 2×0.5 mm2
copper wire to the two-pin power connector of the camera (GND and +12V
phase). The PCB terminal block can be found at the back of the camera. Use a
screwdriver to push in the orange colored plastic spring lifter, connect the
wires then release the spring lifter!
The LED states
•The rear view draw shows the location of the camera LEDs.
LED1 LED2
Indicating Network Link – Activity Power – Ready
State1 Blinking in green
according to Ethernet
communication
Lights up in green if the
camera gets power
State2 Blinking in green and red
if the camera is ready to
use
Connecting the I/O ports
2 programmable Input/Output ports (NO, NC / OC 0.5A/30V) are available in
the camera. Connect the external I/O devices to the appropriate pins (I/O-1
and I/O-2)! The PCB terminal block can be found at the back of the camera.
Use a screwdriver to push in the orange colored plastic spring lifter, connect
the wires then release the spring lifter!
Connect Audio Input
The spring connector of the Audio Input can be found at the back of the
camera marked as MIC. Use a screwdriver to push in the orange colored plastic
spring lifter, connect the wire then release the spring lifter!
2/3

Quick Installation Guide LPIX15-01-S-ABF
Connect Audio Output
The spring connector of the Audio Output can be found at the back of the
camera marked as SPK. Use a screwdriver to push in the orange colored plastic
spring lifter, connect the wire then release the spring lifter!
Camera Log-in
You can find the Logipix Camera’s IP address on a sticker. Start the SCPlayer
program, and then connect to the camera by setting its IP address.
Enter the default user name and password (admin/admin) in the pop-up
password form. Note that user name is case sensitive.
LIMITED LIABILITY WARRANTY
STP Limited warrants the original consumer purchaser, that this Logipix
product is guaranteed for a period of 2 years from the date of purchase against
defects in material and workmanship.
This warranty is limited to repair or replace the product only if the defect has
arose during intended use. The warranty is void if the product malfunctioned
by shipping damage, extreme natural effects outside of the defined
specifications, physical impact, tampering, neglect or any other incorrect use
or natural disasters. STP Limited is not responsible for loss data caused by
unreasonable use of the device.
Warranty service is available contacting the Logipix technical support team via
email: [email protected]
3/3