Lowdi Wireless Mobile speaker User manual

Wireless Mobile speaker lowdi.com

FrontSide
On/Off switch
Micro USB
charging port
Audio input
Main control
button
Volume controls
LED status light
1
2
3
4
5
6
1
4 5
2
3
6

While your device searches, press and hold the button (4)
on the front side of Lowdi for 8 seconds. Lowdi plays a sound
and blinks its LED light (6) once it has entered pairing mode.
Make sure that Lowdi is fully charged and powered ON (1) and
that your Bluetooth-enabled device (phone, tablet, laptop etc.)
is powered on too.
Access the Bluetooth settings on your device and enable
Bluetooth connections. Search for new Bluetooth devices.
Connect
Wirelessly
via Bluetooth

Lowdi is now ready to play your favourite music. Press the
. button (4) to pause and play. You can adjust the volume
with the designated volume | controls (5).
Select ‘Lowdi’ from the list of Bluetooth devices on your audio
device. Lowdi will play a different sound to let you know that
it is connected.
In case the Bluetooth connection is not working properly, please consult the special
notes section on the other side of this document or consult www.lowdi.com.

Make sure that Lowdi is fully charged and powered ON (1)
and that your audio device is powered on too.
Plug the supplied audio cable into the input marked AUX (3).
Lowdi is now ready to play your favourite music.
Connect
via cable

Specifications
TECHNOLOGY
This device supports Bluetooth, built on version 4.0, and is compatible with
most mobile phones, tablets, laptops and other Bluetooth-enabled devices.
BLUETOOTH VERSION
▪Bluetooth v4.0, backwards compatible with previous versions
▪Bluetooth range: 10m, or approximately 33 feet
▪Frequency: 2.4GHz, or 2400MHz
IN THE BOX
▪Lowdi, carrying pouch, USB cable, audio cable, manual, stickers
PRODUCT AND TECHNICAL SUPPORT
▪E-mail: [email protected]
▪Online: www.lowdi.com
WARRANTY AND TERMS OF USE
▪Online: www.lowdi.com/warranty

LOW BATTERY
When Lowdi’s battery is low, the status LED light will blink and an alert will
sound once every 30 seconds. Lowdi will power off automatically 5 to 10
minutes after the first alert.
CHARGING
Charge your Lowdi via the supplied USB charging cable. While Lowdi charges
the status LED will turn on until fully charged. A full charge may take between
2 to 3 hours. When connecting Lowdi to charge via USB while playing, Lowdi’s
signal may stop automatically. Turn the device off and on to resume playback.
Charging Lowdi
PAUSE / PLAY
Short press and release the main control button (4) to play or pause music.
VOLUME ADJUST
You can adjust the volume by using the designated volume controls (5).
PREVIOUS / NEXT
While the music is playing, press and hold the plus button (5) to skip one track
forward. Press and hold the minus button (5) to move one track back.
Audio controls

REDIAL
In standby mode, press the main control button (4) twice.
VOICE DIAL (ON SELECTED DEVICES)
In the standby mode, press and hold the main control button (4) for 3 seconds.
TRANSFER CALL FROM SPEAKER TO PHONE
During a call, press and hold the main control button (4) for 3 seconds until you
hear a tone. The same operation can transfer the sound from your phone to a
Bluetooth speaker.
ANSWER CALL
While paired with your phone, press the main control button (4) to answer an
incoming call.
END CALL
To end a call, simply press and immediately release the main control button
(4). A tone will sound to indicate the function has been completed.
REJECT CALL
Press and hold the main control button (4) for 3 seconds to reject a call. A tone
will sound to indicate the function has been completed.
Additional phone controls

Special notes
Pairing mode will last up to five minutes to ensure the device is found.
Once paired with a device, Lowdi will automatically reconnect when
powered on. To enter pairing mode to connect a different device, first turn
of the Bluetooth of the previously connected device.
When connection is lost due to exceeding the effective range, Lowdi will
automatically reconnect if your device reenters the range within 10 minutes.
Each Bluetooth device is different. Please check the User Guide for your
specific device.
▪
▪
▪
▪
▪
▪
▪
▪
If prompted for a PIN or Password during Bluetooth connection, enter:
0000, and confirm.
Use the supplied audio cable if Bluetooth is not supported on your device.
When connected to a computer via the USB port, Lowdi can function as a
USB speaker on some systems.
In case of playback problems it is easy to reboot your Lowdi. Make sure that
the device is powered on, connect it via the USB charging cable and switch
it off for a few of seconds before turning it on again.

For the safety of the environment, never dispose of any battery in the trash. For
your safety do not damage the battery or dispose of batteries in a fire as this
may cause an explosion.
Although the battery can be charged and discharged multiple times, the
battery will eventually wear over time. Following the advice in this manual can
help improve and extend your battery’s life.
Lowdi is powered by a rechargeable battery. For maximum battery
performance, always use the supplied USB charging cable and promptly
disconnect the device when charging is complete or the battery is full.
Avoid extreme weather conditions, as these may hinder the battery’s capacity.
The ideal temperature for this device is 59°F to 78°F or 15°C to 26°C. Any
extreme weather can impair the performance of the device and may cause it
not to operate.
A fully charged battery left unused may result in complete discharge over an
extended period of time.
Battery information