LOXONE Nano Relay Air User manual

Technical Specifications
Powersupply 110 ... 230VAC, 50/60Hz
Output 1 output (switching supply
voltage),
bistable 16A AC at cos φ=1
Interface Loxone Air:
868MHz (SRD Band Europe),
4 channels available
max. Power 15.1mW e.r.p.
915MHz (ISM Band Region 2),
10 channels available
max. Power 13.2mW
Safety rating IP20
Standby power consumption typ. 0.5W, max. 1.5W
Loxone Electronics GmbH
Smart Home 1
4154 Kollerschlag
Austria
loxone.com
Need Help?
loxone.com/support
V110320
Part No.: 100426
Nano Relay
Air
Power loss at max. load max. 4W
Ambient temperature 0 ... 50°C / 32 ... 122°F
Humdity
Dimensions 71x44x36mm /
2.8x1.73x1.42” (LxWxH)
Maintenance & Cleaning This device is free of
maintenance and may only
be cleaned with a dry cloth.
Operation
max. 90% r. H. (non condensing)
Rated surge voltage of
digital outputs
2.5kV (UL 60730-1,
max. Altitude 2000m)
Degree of pollution 2
Typ 1/Class A
(IEC 60730-1, UL 60730-1)

For additional information, declaration of confirmity,
visit www.loxone.com/help/nano-relay-air
About the product
The Loxone Nano Relay Air is a device for automatic control
and management of bulding automation and similar non
safety critical applications. We recommend it is configured
according to the Loxone Standard and with the help of the
Loxone Config.
Features
•1 freely programmable digital relay output
•overtemperature switch-off 87°C / 189°F processor
temperature
•expandable with Touch for Nano via plug-in connector
Status
LED
Learn
Button
Plug-in
connector
Load
Hot *
Neutral
Installation
The installation of this device has to be carried out by a
qualified person. The device has to be fitted in accordance with
building regulations for electrical and fire safety. This requires
an installation box or additional enclosure.
If the device is not installed according to manufacturers
guidelines the protection of the device may be affected.
Information
Contains FCC ID: 2ARRV-000376
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired operation
Connection Cables
Wire cross-section 1.5mm² / AWG 16
Temperature resistance min. 80°C / 176°F for IEC,
min. 75°C / 167°F for UL
Stripping length 5mm / 0.2”
Cable Length 125mm / 4.92"
Wire cross-section 1.5 … 4mm² /AWG16 … 12
Temperature resistance max. 85°C / 185°F
Stripping length 11mm / 0.43”
Leaver Connectors
* building fuse 20A required